Furuno MU-150C Fastening the front panel, Connection of cables at the rear of the display unit

3.Loosely screw six screws (M5X15) into the holes at the rear of the display unit. Set the screws on the display unit to the holes on the bracket and then tighten the screws. (Note that the display unit may also be mounted in portrait orientation.)

Fastening the front panel

4.Fasten the power cable (local supply in case of AC power), cable from the control and operation sections of external equipment and ground wire (local supply) at the rear of the MU-150C. For use of the cable type 06S4078 (from a control section), cut off the connector’s rubber cover and remove the fixing metal to enable connection.

NMEA	Cable from control section
Cable from operation section	06S4078 *5m*
MJ-A10SPF0002
	Power Cable
	Ground Wire
DISPLAY
UNIT

Connection of cables at the rear of the display unit

4