APPENDIX
Modification for Switching from Landscape to Portrait Orientation
To use the
1.Place the display unit on a workbench with the LCD side down. It is recommended to place the unit on cushioning material so as not to place pressure on knob.
2.Unfasten the items marked with white arrows in the figure below to remove the cover for the power section and connectors: 10 screws, four spacers for connectors and two nuts of waterproof connectors. This gives access to the CONE Board (10P6877) and power assy.
Display unit, rear view
3. Remove the 14 screws marked with gray arrows in the figure above.