Furuno MU-150C manual Wiring External Equipment, General-purpose monitor

2 WIRING

2.1 Wiring External Equipment

Connect external equipment to the MU-150C by referring to the drawings in this section. A cable with connector at both ends is provided to connect equipment.

General-purpose monitor

To use the MU-150C as a general-purpose monitor, connect equipment with a mini D-SUB 15P connector. In this case do not connect a navigator to the NMEA port. Nav data is output through the D-SUB 25P connector.

Mini D-SUB 15P

CH-37: DISPLAY

CH-250: INTERFACE UNIT RGB OUT

FCV-1200 Series: INTERFACE UNIT RGB OUT

FCV-1500 Series: DISPLAY UNIT DISPLAY

GP/GD-280/380/680: DISPLAY UNIT EXT VIDEO

FR-1500 MK3 Series: Connector on RGB BUFFER board in display unit

FR-1760DS: Connector on RGB BUFFER board in display unit

24 VDC

or 100-240 VAC Ground

Terminal

Display unit, rear view, wiring using general-purpose cables

Note: When connecting a general-purpose monitor, use the following cable or the equivalent:

Mini D-sub 15P: EVNPS05-50 ft, male-male, (max. 15 m)

Manufacturer: BlackBox Japan

7