Connect Tech CTIM-00043 user manual Copyright Notice, Trademark Acknowledgement, Revision History

Page 4

CANpro/104 User Manual

Copyright Notice

The information contained in this document is subject to change without notice. Connect Tech Inc. shall not be liable for errors contained herein or for incidental consequential damages in connection with the furnishing, performance, or use of this material. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of Connect Tech, Inc.

Copyright © 2009 by Connect Tech Inc.

Trademark Acknowledgement

Connect Tech Inc. acknowledges all trademarks, registered trademarks and/or copyrights referred to in this document as the property of their respective owners.

Not listing all possible trademarks or copyright acknowledgments does not constitute a lack of acknowledgment to the rightful owners of the trademarks and copyrights mentioned in this document.

Revision History

Revision 0.02	January 15, 2010
	Updated manual with Rev.C (or later) Boards
Revision 0.01	December 22, 2008
	Updated manual to new format
	Updated Table 3
Revision 0.00	Original Document

CTIM-00043 (0.01) 1/15/2010	www.connecttech.com	4
	800-426-8979 519-836-1291

Image 4

Contents CANpro/104 CTIM-00043 0.02 January 15Table of Contents CTIM-00043 0.01 1/15/2010 Trademark Acknowledgement Copyright NoticeRevision History Features IntroductionMemory vs I/O Spaces Hardware Installation Rev C & LaterMemory Space CTI CANpro/104 Spaces SpaceMemory Space Enabling J3A Position #1 FunctionBase Address Decoding AddressPosition #5 Position #6 Position #7 Jumper Memory Space Position Address Bit GroupWhen Memory Space is selected When I/O Space is selectedAddress Bit J3A or J3B Installed Value Position Or Removed PeliCAN vs BasicCAN Addressing ModesAddressing Examples J3C Position #2 FunctionExample #3 0x340 = XXXX.XXXX.XXXX.X 011.01CJ.JJJJ binaryExample #4 0x600 = XXXX.XXXX.XXXX.X 110.CJJJ.JJJJ binaryCan Controller Addressing Table Base Common Memory Space Address SelectionsMemory Address Interrupt Mode and Selections 9D Connector Shell GroundPerformance Enhancement Can Bus OptionsSingle Interrupt Mode Dual Interrupt ModeShared Interrupt Mode Can Bus Dominant Timeout and Minimum SpeedPosition Function Jumper Installed Jumper Removed Security ID FeatureJumper Summaries J3B J4 and J5Hardware Installation Rev a & B CANpro/104 Opto DiagramsInterrupts and Memory I/O Range Selection Unique Interrupt LinesSharing a Single Interrupt Line No InterruptsAddress Mode and Range Selection CanInterrupt Sharing Other On-board Jumper Selection DB-9 Cable Connector Pinouts Pin No Signal Connector Pinouts10-pin Header Pinouts Pin No Signal Certification SpecificationsCertification for CANpro/104 Telephone/Facsimile Email/Internet Mail/Courier