Connect Tech user manual CTIM-00043 0.01 1/15/2010

Page 3

	CANpro/104 User Manual
J3A	16
J3B	17
J3C	17
J4 and J5	17
Hardware Installation – Rev A & B	18
CANpro/104 Opto Diagrams	18
Interrupts and Memory I/O Range Selection	19
Interrupt Selection	19
Unique Interrupt Lines	19
Sharing a Single Interrupt Line	19
No Interrupts	19
Address Mode and Range Selection	20
Interrupt Sharing	21
Other On-board Jumper Selection	22
Connector Pinouts	23
Specifications	24
Operating Environment	24
Power Requirements	24
PC Bus Interface	24
Optical/Power Isolation (CANpro/104 Opto models only)	24
Dimensions	24
Connectors/Interface	24
Certification	24
Certification for CANpro/104	24
Limited Lifetime Warranty	25
Customer Support Overview	25
Contact Information	25

3	www.connecttech.com	CTIM-00043 (0.01) 1/15/2010
	800-426-8979 519-836-1291

Image 3

Contents CTIM-00043 0.02 January 15 CANpro/104Table of Contents CTIM-00043 0.01 1/15/2010 Copyright Notice Trademark AcknowledgementRevision History Introduction FeaturesHardware Installation Rev C & Later Memory vs I/O SpacesMemory Space J3A Position #1 Function CTI CANpro/104 SpacesSpace Memory Space EnablingJumper Memory Space Position Address Bit Group Base Address DecodingAddress Position #5 Position #6 Position #7When I/O Space is selected When Memory Space is selectedJ3C Position #2 Function Address Bit J3A or J3B Installed Value Position Or RemovedPeliCAN vs BasicCAN Addressing Modes Addressing Examples0x600 = XXXX.XXXX.XXXX.X 110.CJJJ.JJJJ binary Example #30x340 = XXXX.XXXX.XXXX.X 011.01CJ.JJJJ binary Example #4Can Controller Addressing Table Common Memory Space Address Selections BaseMemory Address Can Bus Options Interrupt Mode and Selections9D Connector Shell Ground Performance EnhancementCan Bus Dominant Timeout and Minimum Speed Single Interrupt ModeDual Interrupt Mode Shared Interrupt ModeSecurity ID Feature Position Function Jumper Installed Jumper RemovedJumper Summaries J4 and J5 J3BCANpro/104 Opto Diagrams Hardware Installation Rev a & BNo Interrupts Interrupts and Memory I/O Range SelectionUnique Interrupt Lines Sharing a Single Interrupt LineCan Address Mode and Range SelectionInterrupt Sharing Other On-board Jumper Selection Connector Pinouts DB-9 Cable Connector Pinouts Pin No Signal10-pin Header Pinouts Pin No Signal Specifications CertificationCertification for CANpro/104 Email/Internet Mail/Courier Telephone/Facsimile

Optical/Power Isolation (CANpro/104 Opto models only)

CTIM-00043 (0.01) 1/15/2010