Connect Tech CTIM-00043 user manual When Memory Space is selected, When I/O Space is selected

CANpro/104 User Manual

1.X = Address bit is ignored (and the corresponding Jumper is Not Used).

2.When Memory Space is selected, PC/104 Address bits 20 and 21 are always decoded as logical

“0”.

To determine which Jumpers to install and which to remove, the desired Address needs to be broken down into a binary number, all the Jumpers that correspond to “1-bits” must be installed, and all Jumpers corresponding to “0-bits” must be removed.

The remaining lower bits of the PC/104 Bus Address are either, ignored, or are used to select and address the Registers of the SJA1000 CAN controllers, in the following manner.

	When Memory Space is selected
	PC/104 Bus	SJA1000 Selection
	Address Bit	or Register Address Bit
	12	Address bit is ignored
	11	Address bit is ignored
	10	Address bit is ignored
	9	Address bit is ignored
	8	Address bit is ignored
	7	Select SJA1000 device
		=0, selects the CAN-0 Port
		=1, selects the CAN-1 Port
	6	6
	5	5
	4	4
	3	3
	2	2
	1	1
	0	0
	Table 5
	When I/O Space is selected
	PC/104 Bus	SJA1000 Selection
		or Register Address Bit
	Address Bit
		PeliCAN Addressing Mode	BasicCAN Addressing Mode
	10	Decoded (see Table 4)	Decoded (see Table 4)
	9	Decoded (see Table 4)	Decoded (see Table 4)
	8	Decoded (see Table 4)	Decoded (see Table 4)
	7	Select SJA1000 device	Decoded (see Table 4)
		=0, selects the CAN-0 Port
		=1, selects the CAN-1 Port
	6	6	Decoded (see Table 4)
	5	5	Select SJA1000 device
			=0, selects the CAN-0 Port
			=1, selects the CAN-1 Port
	4	4		4
	3	3		3
	2	2		2
	1	1		1
	0	0		0
	Table 6
9		www.connecttech.com		CTIM-00043 (0.01) 1/15/2010
		800-426-8979 519-836-1291