Buffalo Technology WLM2-G54 manual Part

Page 3

Warning	...........................................................................................................................................................................................................................................................................................	iii
PART I
1.0	Introduction I	1
1.1	Summary of Features	1
2.0	Package Contents	1
3.0	System Requirements	1
4.0	Product Views	1
5.0	Features	3
5.1	Security Features	3
5.1.1	Authentication	3
5.1.2	Privacy	3
5.1.3	Access Authorization	3
5.1.4	IBSS Security	3
5.2	Integrity Features	3
5.2.1	Improved Fault Tolerance	3
5.2.2	Link Integrity	3
5.2.3	Spanning Tree (IEEE802.1d)	4
5.3	Network Load Distribution Features	4
5.3.1	Load Balancing	4
5.3.2	Repeater	4
5.3.3	WDS – Wireless Distribution System	4
5.4	Network Administration Features	4
5.4.1	SNMP – Simple Network Management Protocol	4
5.4.2	Syslog	4
5.5	Easy Support Features	5
6.0	Network Solutions	5
6.1	Typical Office Situations	5
6.2	Apartments or Condominiums	5
6.3	Schools	7
6.4	Hospitals	7
6.5	Factories	7
6.6	Area Intranets	7
7.0	Support Functions	7
7.1	PoE - Power over Ethernet	7
7.2	Environmental Resistance	8
7.3	Upgradeable Firmware	8
7.4	Diagnostic Support	8
PART II
8.0	Client Configuration	8
8.1	Introduction II	8
8.2	Setup Preparation	8
8.3	Setup Overview	8
8.4	Installation of the Client Manager	8
8.5	Setup Screen	9
8.6	Input Parameters Through the Client Manager	10
8.7	Input Parameters Through a Wired PC,Terminal Software	10
8.8	Input Parameters Through a Wired PC,Telnet Software	11
PART III
9.0	Detailed Configurations	12
9.1	Introduction III	12
9.2	Basic Settings	12
9.2.1	AirStation Name	12
9.2.2	Connection type	12
9.2.3	IP Address	12
9.2.4	Default Gateway	12
9.2.5	DNS Server	12
9.3	Time Settings	13
9.4	Management	13
9.4.1	Host Setup	13

i

Image 3

Contents WLM2-G54 Page Part 10.1 Iii SignsSystem Requirements Summary of FeaturesPackage Contents IntroductionPrivacy FeaturesSecurity Features AuthenticationIbss Security Access AuthorizationIntegrity Features Improved Fault ToleranceNetwork Administration Fea Tures Network Load Distribution FeaturesApartments or Condominiums Easy Support FeaturesNetwork Solutions Typical Office SituationsSchools HospitalsFactories PoE Power over Ethernet Area IntranetsSupport Functions Setup Preparation Upgradeable FirmwareDiagnostic Support Client Configuration IntroductionSetup Screen After finding an AirStation, select Admin / Set IP addressInput Parameters Through the Client Manager Input Parameters Through a Wired PC,Terminal SoftwareSelect Start / Run Input Parameters Through a Wired PC,Telnet SoftwareBasic Settings Detailed Configurations IntroductionManagement Time SettingsBridge System1=General administrative informationRouting Server Name=The name of the Radius server or the IP address See next Manual SettingBasic Filter Basic Filter InformationAdd Peer AirStation MAC Address List of the Wireless PCsAuthorized Wireless LAN PCs Wireless11 Link Integrity Settings 10 WirelessPS Privacy Separator Configure EAP in the Security/802.11g screen Privacy, WEPLink Integrity Settings Digits of hexadecimal numbers, i.e. a3d58b62feAdd AirStation Connected AirStation Wireless Distribution System SettingsDiagnostics Introduction Parameters for the Diagnostic Operation3 Wireless LAN PC Information See previous Wireless LAN PC Information5 Ping Test Appendix a Additional InformationAppendix a Intelligent Access Point WLM2-G54 Specifications Table B.1 Diag LED Activity Table Appendix B TroubleshootingOther Problems LED ActivityDTE Data Terminal Equipment Device CRC Cyclic Redundancy CheckDCE Data Communications Equip Dsss Direct Sequence SpreadPCI Peripheral Component Intercon Radius Remote Authentication DialRAM Random Access Memory Non Mips Millions of Instructions PerSnmp Simple Network Management Wlan Wireless LAN a LAN topologyROM Read Only Memory Permanent Smtp Simple Mail Transfer ProtocolPage Page Buffalo Technology Technical Support