| CLI Commands | |
Table 3: CLI Commands (Sheet 2 of 2) | ||
|
|
|
Command | Description | |
|
|
|
DISABLE_WEB_SERVER] | Disables access to the DSLAM using the web server. | |
|
|
|
ENABLE_TELNET | Enables access to the DSLAM using Telnet. | |
|
|
|
ENABLE_TFTP | Enables access to the DSLAM using Trivial File Transfer Protocol. | |
|
|
|
ENABLE_WEB_SERVER | Enables access to the DSLAM using the web server. | |
|
|
|
HELP | Lists available commands and their syntax. | |
|
|
|
LOGOUT | Ends the CLI session. | |
|
|
|
SET | Sets a configuration option. Most SET commands require that slot | |
| be specified, and allow port optionally to be specified. Exceptions | |
| are the two system SET commands for session timeout and system | |
| name. | |
| Syntax: | |
| set cli_session_timeout seconds | |
| set system_name name | |
| set slot 1 [[port] [all, port_number]] [item] [value] | |
| Items and values for SET commands are shown in Table 4, Set and | |
| Show Command Items and Values. | |
|
|
|
SHOW | Shows a configuration option. SHOW commands require that slot be | |
| specified, and allow port optionally to be specified. | |
| Syntax: | |
| show slot 1 [[port] [all, port_number]] [item] [value] | |
| Items and values for SHOW commands are shown in Table 4, Set | |
| and Show Command Items and Values. | |
|
|
|
WHO | Shows who is logged in the system. | |
|
|
|
The commands use the following parameters.
Table 4: Set and Show Command Items and Values (Sheet 1 of 3)
Items | Values |
|
|
ADSL_ENCAPSULATION | |
|
|
ADSL_PORT_MODE | [ON,OFF,ADAPTIVE,FIXED_ADAPTIVE] |
|
|
ADSL_SPEED | [XXXX YYYY] |
Where:
XXXX= downstream rate (in kbps) and
YYYY= upstream rate (in kbps)
| 4929 DSLAM Installation and User’s Guide | 77 |