Zhone Technologies 5620 What Does the Hotwire Radsl RTU Do?, Package Checklist

Page 2

Package Checklist

Verify that your package contains the following:

￿Model 5620 Remote Termination Unit (RTU)

￿DSL interface cable with RJ11 connectors

￿Power cord with power transformer

￿Two ferrite chokes

What Does the Hotwire RADSL RTU Do?

The Hotwire 5620 RTU is a component in the Hotwire DSL Access System. This system provides high-speed Internet or corporate LAN access over traditional twisted-pair copper telephone wiring.

A POTS splitter blocks out the DSL signal and allows the POTS frequencies to pass through. At the customer premises, the RADSL RTU and a telephone can function simultaneously over the same pair of copper wires when either:

HA Hotwire 5030 or 5038 POTS Splitter is installed near the demarcation point for all telephones on the same POTS line as DSL, or

HA Hotwire 5038 Distributed POTS Filter is installed on each telephone on the same POTS line as DSL.

DSL Access with a Hotwire 5030 or 5038 POTS Splitter

Copper pairs run from the central office (CO) to the customer premises (CP) to create the local loop. The local loop terminates on the customer premises at the demarcation point in a punchdown block or network interface device (NID).

The Hotwire 5030 POTS splitter is designed for outdoor or indoor installation. The Hotwire 5038 POTS Splitter is designed for indoor use only.

When a Hotwire POTS splitter is used at both ends of the local loop, wiring is connected:

HFrom the demarcation point to the CP POTS splitter, and

HFrom the demarcation point to the DSL jack.

NOTES:

ÐEnd-user system is used to represent any PC with an Ethernet connection and DSL-based service.

ÐNetwork Service Provider (NSP) is used to represent any Internet Service Provider (ISP) or remote LAN access provider.

2

Image 2
Contents Document Number Document Title Wiring and Cables NeededBefore You Begin DSL Access with a Hotwire 5030 or 5038 Pots Splitter What Does the Hotwire Radsl RTU Do?Package Checklist Customer Premises CP DSL Access with a Hotwire 5038 Distributed Pots SplitterNetwork Service Provider DSL Access without a Pots Splitter DSL RTUPunchdown Block Installing the DSL Access WiringProcedure Telephone Network Interface Device NID DSL/POTSPOTS/DSL RJ11 Wall JackPots Splitter Installing the Hotwire 5620 RTUHotwire RTU Ethernet Line Ferrite Optional RTU Wall Placement RTU Hardware Template Status LEDs Power-OnAlarm red Condition StatusIncreasing the Number of End-User Systems TroubleshootingLED Symptom Action NSPCables & Connectors Pin # FunctionModel 5620 RTU Technical Specifications SpecificationImportant Safety Instructions Declaration of Conformity Canada EMI Warnings Document Feedback Warranty, Sales, and Service InformationTrademarks