Using Telnet
Using Telnet You can use Telnet to interrogate and program an AH2072 NMM NMM with a NetStacker hub or AsantéHub 2072.You can do this using any
ΔInformation on installing Telnet is not provided in this manual. Refer to the documentation that comes with the Telnet software.
The following list is a summary of the steps you need to perform to use Telnet with an AH2072 NMM connected to a NetStacker hub or an AsantéHub 2072.
❏Install the image code on the AMS
❏Upgrade the hub’s image code
❏Establish a link with the hub using Telnet
This procedure assumes you‘ve already done the following:
❏Installed AsantéView
❏Connected appropriate cables for
❏Set hub DIP Switches if needed
❏Assigned an IP address to the hub
❏Installed the Telnet application on your network management station
Refer to the Telnet software documentation for installation instructions. See the appropriate AsantéView User’s Guide for information on installing and configuring the appropriate soft- ware and hardware for using AsantéView.
Installing the Image Code Before you upgrade the image code in the AH2072 NMM with a NetStacker hub or AsantéHub 2072, you need to install the image code files on the AMS. Table 3 lists the files you need.
Table 3 Image Code File Names
AsantéHub 2072
2072huxx.17x or higher
2072h.cfg
Page 21