Asante Technologies 2072 manual Isolating Modules from the Network, Segment LED States

Page 41

AsantéHub 2072 Network Management Module Installation Guide

Isolating Modules from the Network

3

Press the Change Segment button repeatedly until you

 

have chosen the segment you want: Seg 1, Seg 2, or

 

neither.

4

When you have chosen your segment, press both the

 

Select Slot and Change Segment buttons together. In

approximately two to three seconds, the change is made and the specified segment’s LED lights; the unspecified segment’s LED darkens. (See Figure 27 on page 39.)

Δ Network statistics cannot be collected if a mod- ule is isolated from both segments.

To isolate (remove) a particular module from the network, press both the Select Slot and Change Segment buttons simultaneously. Both segment LEDs for the selected slot remain lit. Table 4 identi- fies the LED states for both segments while you are cycling through the process (changing from one segment to another).

Table 4 Segment LED States

LED State

Meaning

 

 

 

Seg 1

LED, On

This particular slot is connected to Seg 1.

Seg 2

LED, On

This particular slot is connected to Seg 2.

Seg 1

& Seg 2, Off

There is no segment connection.

 

 

 

▲If your AsantéView Management Station (AMS) is on one segment, and you change the NMM to the other segment, you will not be able to communi- cate with the NMM (provided a bridge does not exist between the two segments).You lose your Telnet connection and SNMP capabilities.

You can reestablish communication with the module by changing the segment using the Select Slot and Change Segment buttons on the hub, by connecting your AMS to the other segment, or by using AsantéView Out-of-Band.

Page 40

Page 40 Page 42
Image 41
Page 40 Page 42
Contents AsantéHub 2072 Network Management Module Installation Guide AsantéHub Network Management Module Installation Guide Asking for Assistance AsantéHub 2072 Network Management Module Installation GuideTell Us What You Think Tell Us What You ThinkAH2072NMM Introducing Network Management ModuleIntroducing the Network Management Module Grounding Requirements Checking Package Contents Segment Control InstallationDIP Switch Function of NMM Front Panel Components Front PanelAsanteview OUT-OF Front Panel Cable Connections to Other Devices AMS Link Connecting Hubs in an Out-of-Band Daisy-ChainHub Cable Connections to Other DevicesSummary of DIP Switch Settings DIP switch settings for Out-of-Band using AMS Link Configuration Connecting a Modem to the HubRS232/AMS Link Configuration DIP Switch Setting Using the Local Management PortConnect a straight-through RS232 cable to the RS232 AsantéTerm Icon Using AsantéTermAsanté Remote Management System Main Menu using AsantéTerm Using Telnet Icon for NCSA/BYU Telnet 2.5 Macintosh Upgrading the Hub Image CodeClick the OK button. shows the Asanté General Guidelines Using the Asanté Remote Management SystemAsanté Remote Management System Menu Tutorial Using the Asanté Remote Management SystemExample General Configuration Screen Type the password Asante the password is case-sensi Type a from the Configuration menu.This takes you to Type Office Hub 2072 or a different name if you wish Press q to return to the Configuration menu Configuration Menu Accessing the Configuration MenuConfiguration Menu System Administration Information Group Parameters Console Password Reset System Type c for Console Password Type the new password a second time and press Segment Control An Example for Segmenting the NetworkSelecting a Slot for Segment Change Segment ControlSegment LED States Isolating Modules from the NetworkTechnical Specifications Technical SpecificationsRS232 Connections Index IndexEeprom MIB Snmp
Top Page Image Contents