SECTION 3 | CONFIGURATION |
|
|
To access the screen, click NETWORKING > PORT TRIGGER. Click
APPLY to save your settings or CANCEL to cancel changes.
To add a Port Trigger entry:
1Port Trigger Name: Enter the name of the application. There is a limit of 32 characters for the name. Click to enable if you wish it to become active. Otherwise, you can save the information and enable it at later date. To enable at a later date, select the entry, check enable, then click Update.
2Outgoing Protocol: From the drop down box, select from TCP, UDP, or Both.
3Outgoing Port: Enter the From and To ranges (0 to 65535) for your application.
4Trigger Incoming Protocol: From the drop down box, select from TCP, UDP, or BOTH.
5Incoming Port Range: Enter continuous value(s) (0 to 65535), separated by dashes, for your application. You can also enter multiple
6Port Trigger Idle Time: Enter the elapsed time before the port mapping closes.
To update or remove an entry, select it and then click Update or
Remove to perform the action.
SECTION 3, CONFIGURATION |