Aiwa CX-NV8000 manual Troubleshooting Guide Parts Index, CD Player Section

Page 24

TROUBLESHOOTING GUIDE

PARTS INDEX

[f the unit fails to perform as described in these Operating Instructions, check the following guide.

GENERAL

There is no sound.

Is the AC cord connected properly?

“Is there a bad connection? (+ page 3)

*There may be a short circuit in the speaker terminals.

+Disconnect the AC cord, then correct the speaker connections.

Was an incorrect function button pressed?

Sound is emitted from one speaker only.

Is the other speaker disconnected?

The output sound is not stereo.

Is the Karaoke function turned on? (+ page 17)

An erroneous display or a malfunction occurs.

+Reset the unit as stated belovy.

TUNER SECTION

There is constant, wave-like static.

Is the antenna connected properly? (+ page 3)

Is the signal weak?

+ Connect an outdoor antenna.

The reception contains noise interferences or the sound is distorted.

Is the system picking up external noise or multipath distortion?

+Change the orientation of the’antenna.

+Move the unit away from other electrical appliances.

CASSETTE DECK SECTION

The tape does not run.

Is deck 2 in pause mode? (+ page 11)

The sound is off-balance or not adequately high.

Is the playback head dirty? (+ page 21)

Recording is not possible.

IS the erasure prevention tab on the tape broken off? (+ page 12)

Is the recording head dirty? (+ page 21)

Erasure is not possible.

c Is the erasure head dirty? (+ page 21)

is a metal tape being used?

High frequency sound is not emitted.

Is a tape recorded without Dolby NR played back with the Dolby NR system operating? (+ page 11)

Is the recording/playback head dirty? (+ page 21)

CD PLAYER SECTION

The CD player does not play.

Is the disc correctly inserted? (+ page 9)

1s the disc dirty? (+ page 21)

Is the lens affected by condensation?

+ Wait approximately one hour and try again.

To reset

If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.

1Press the POWER button to turn off the power.

2Press the POWER button to turn the power back on while pressing the CLEAR button. Everything stored in memory

after purchase is canceled.

If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord and repeat step 2.

Instructions about each part on the main are indicated on the pages listed below.

(in alphabetic order)

Parts

CD

CD EDIT/CHECK (EDIT/CHECK)

CLEAR

CLOCK DEMO DIGITAL ECHO

4P DIRECTION/PRESET DISC CHANGE

DISC DIRECT PLAY DOLBY NR

44, 1<< DOWN

EDIT/CHECK (CD EDIT/CHECK) FRONT SURROUND

GEQ

KARAOKE (VOCAL FADER/MULTIPLEX) KARAOKE ENTER

MIC 1, MIC2

MIC MIXING

= OpEN/CLOSE

PHONES

POWER

PRGM RANDOM

(0/0) REC/REC MUTE REPEAT/MONO TUNER REV MODE (DECK 2)

IISET SLEEP

SYNC DUB NORM/HIGH TAPE/DECK 1/2

T-BASS TIMER TUNER/BAND FFI, > UP VI DEO/AUX

VOCAL FADER/MULTIPLEX (KARAOKE) VOLUME

o-9, +10

unit or remote control

Pages

9

9, 15, 16 8, 9, 11 5 5 17

8,9, 11 9 9 12

7, 9, 11 9,15,16 7 6 17 18 17 17 9 6 5 10 10 13

7, 10 11 8, 9 20 14 11, 13 6 19 7

7, 9, 11 21 17 6 10

23 ENGLISH

Image 24
Contents ~ll Toll Free I-800-BUY-AIWA Table of Contents Precautions Before connecting the AC cord ConnectionsConnect the right speaker to the main unit Connect the left speaker to the main unitConnecting AN Outdoor Antenna Remote ControlConnect thesupplied antennas Connect the AC cord to an AC outletBefore Operation Press the II SET buttonAdjusting the Sound Volume ControlSound Adjustment During Recording BBE SystemManual Tuning Front Surround SystemPress the 144 Down or WI UP button to select a station Presetting Stations Preset Number TuningSelecting a preset number on the main unit To clear a preset stationBasic Operations Loading DiscsPlaying Discs To check the remaining timePress the Prgm button twice in stop mode Random PlayRepeat Play Programmed PlayBasic Operations ~ Playing Back a TapeInserting Tapes Music SensorContinuous Play Basic Recording Inserting Blank SpacesDubbing a Tape Manually Dubbing the Whole TapePress the Dolby NR button to turn off the Dolby NR Press the TAPE/DECK 1/2 button to select deckTo stop recording Time on cassette tapes and editing timeTo clear the edit program To check the order of the programmed track numbersProgrammed Edit Recording Repeat for the rest of the tracks for side aTo change the program of each side Then program tracks again To clear the edit programAdjust the echo with the Digital Echo control Microphone MixingVocal Fadewmultiplex Functions Connect your microphones to the MIC 1 and MICKaraokeprograms Setting the Timer Timer RecordingPrepare the source Setting the Sleep Timer Connecting Optional EquipmentVIDEO/AUX Jacks CD DIGITAL, OUT Optical JackCare and Maintenance Listening to External SourcesPress the VIDEO/AUX button Play the connected equipmentSpecifications Dolby NRTroubleshooting Guide Parts Index CD Player SectionFiaure2 I Stereo effect with aconventional sr3eaker System TEizEl Stereoeffectwith Aiwa Frcmt180 speaker systemIndice Precauciones Conexiones Antes de conectar el cable de alimentacion de CAConecte el altavoz derecho a la unidad principal Conecte el altavoz izquierdo a la unidad principalConexion DE UNA Antena Exterior Conecte Ias antenas suministradasConecte el cable de alimentacion de CA a una toma de CA Para cancelar el modo Demo Antes DE LA OperacionPuesta EN Hora DEL Reloj Control DE Volumen Ajijste DEL SonidoSistema BBE Sistema Super T-BASSSistema Delantero DE Sonido Ambiental Sintonizacion ManualFM- AM Pulse el boton l Down o FFI UP para seleccionar una emisoraPreajuste DE Emisoras PreajustePulse el boton I I SET para almacenar la emisora Selecci6n de un numero de preajuste en la unideid principalIntroduction DE Discos Reproduction DE DiscosReproduction Aleatoria Repetition DE ReproductionReproduction Programada Pulse dos veces el boton Prgm estando en el modo de paradaOperaciones Basicas Insercion DE CintasReproduction DE UNA Cinta Sensor MusicalReiwiduccion Continua Acerca de Ias cintas de caseteLJ~ Grabacion Basica Insercion DE Espacios SIN GrabarPulse el boton Dolby NR para activar o desactivar Dolby NR Pulse el boton REC/REC Mute para iniciar la grabacionCopiado Manual DE UNA Cinta Puke el boton Dolby NR para desactivar Dolby NRPuke el boton TAPE/DECK 1/2 para seleccionar la platina Puke el boton @ REC/REC Mute para iniciar la grabacionPara detener la grabacion Para borrar el programa de editionTiempo de Ias cintas de casete y tiempo de edition Grabacion CON Edicion ProgramadaMezcla Microfonica MIC MixingProgramas DE Karaoke Ajuste DEL Temporizador Grabacion CON TemporizadorPrepare la fuente de sonido Ajuste DEL Tempofuzador Para Dormir Tomas VidhyauxToma CD Digital OUT Optical Sonido Externas Escucha DE Fuentes DECuidados Y Iviantenimiento Especjficaciones Dolby NRIndice DE LAS Partes GeneralidadesSeccion DEL Sintonizador Seccion DE LA PlatinaPi&c4@tidw24waft7du.&ue4ai?&4@wa!8?go0ti4?74iw DES Matieres Eneraie electriaue Cordon d’alimentation secteurEntretien Dommaae necessitant une reparationConnexions Avant de brancher Ie cordon secteurConnecter I’enceinte droite a I’appareil principal Surround Speakers RTelecommande Connexion D’UNE Antenne EXTEFUEI.JREReglage DE L’HORLOGE Avant LwtilisationHeures Reglage DIJ SON Pour annuler Ie mode selectionne Systemesurround Avant Accord ManuelFM AM Quand la source musicale est monophoniqueMemorisation DE Stations Appuyer sur la touche Tune Iwband poIurRep&er Ies etapes 1 et Selectionner une gammeOperations DE Base Mise EN Place DE DisquesLecture DE Disques Appuyeu’ deux fois sur la touche Prgm clans Ie mode arr Lecture AleatoireLecture Repetee Lecture ProgrammedOperations DE Base Mise EN Place DE CassettesLecture D’UNE Cassette Senseur DE MusiqueLecture Continue Au sujet des cassettesLe ruban magnetique des cassettes de 120 minutes Systeme reducteur de bruit DolbyEnregistrement DE Base Insertion D’ESPACES BlancsInserer la cassette a enregistrer clans la platine Duplication Manuelle D’UNE Cassette Duplication DE LA Totalite ’UNE CassettePour arkter la duplication Pour arr&er la duplicationEnregistrement Avec Montage ET Calcul DU Temps Pour arrtXer I’enregistrementPour effacer Ie programme du montage Pour contr61er I’ordre des numeros des plages programmersEnfhhstrement Avec Montage Programme Specifier laMepeIer Ierape a pour e res~e aes pmges ae la face a FfAvgxsRegler I’echo avec la commande Digital Echo Mixage Avec MicrophoneFonctions Vocal FADER/MULTIPLEX Brancher Ies microphones aux prises MIC 1 et MICProgrammed DE Karaoke Pour ajouter une reservation pendant la lecturePour contrder Ees plages reservees Pour sauter une plageEnregistrement Commande PAR LA Minuterie Sur la touche Power pour mettre I’appareil hors tensionReglage DE LA Minuterie Preparer la sourceReglage DE LA Minuterie Iyarret Prises VIDEO/AUXPrise CD Digital OUT Optical Pour connecter un tourne-disqueEcoute DE Sources Externes Soins ET Entretien Appuyer sur la touche VIDEO/AUXPour regler Ie niveau sonore de la source externe Soin des cassettesEnceintes Acoljstiques SX-ANV8000 Reducteur DE Bruit DolbyEN CAS DE Probleme NomenclaturePartie Magnetocassette CD EDIT/CHECKEDIT/CHECK H ClearPmq ~ur,ooEncemteacoustique a diffusion frcmtale Aiwa a diffusion sonore frontale surPage Page Copyright Derechos DE AutorDroits D’AUTEUR

CX-NV8000 specifications

The Aiwa CX-NV8000 is a remarkable all-in-one audio solution that caters to both audiophiles and casual listeners alike. This compact stereo system combines cutting-edge technology with user-friendly features to deliver an exceptional listening experience.

One of the main highlights of the CX-NV8000 is its powerful amplifier, which ensures that high-quality audio output is achieved across various genres of music. With a total output power of 200 watts, it provides ample volume levels without compromising sound clarity. The system is designed to accommodate a wide range of audio formats, including CDs, cassette tapes, and FM/AM radio, allowing users to enjoy their favorite music in various ways.

The CX-NV8000 is equipped with a digital tuner, which stands out with its ability to automatically search for and store radio stations, making tuning in to broadcasts a hassle-free experience. Additionally, the system features a built-in equalizer that allows users to customize their audio experience, adjusting the sound according to their preferences.

One of the standout technologies in this stereo system is the inclusion of a CD player that supports both standard CDs and CD-R/RW formats. This versatility ensures that users can listen to their extensive CD collections, including personalized CDs with their favorite tracks. The front-loading design makes it easy to swap out discs on the fly.

Connectivity is another strong point for the CX-NV8000. The system includes multiple inputs such as USB and AUX ports, enabling users to connect external devices like smartphones and tablets effortlessly. This feature is perfect for streaming music or accessing digital libraries.

The design of the Aiwa CX-NV8000 is both stylish and functional, with a sleek black finish and an intuitive control layout that makes navigation straightforward. The LED display clearly shows the track information, making it easy to see what you’re listening to at a glance.

Furthermore, the system’s speaker setup is designed to enhance sound quality, providing a rich and immersive listening experience. The powerful bass and clear treble work together to create a balanced soundscape, perfect for various audio experiences, from powerful rock anthems to delicate classical pieces.

In summary, the Aiwa CX-NV8000 stands out as a versatile and powerful audio system, incorporating modern technology with classic functionality. Its combination of power, connectivity options, and user-friendly features makes it an excellent choice for music lovers looking to elevate their listening experience.