Aztech Systems WL630PCI Installation, System Requirements, Install the Driver & Utility

Page 5

User Manual

2 Installation

2.1 System Requirements

•Desktop PC

•Pentium® 233 processor or higher

•128MB RAM

•A free PCI-Bus slot

•20MB hard disk space (system files and modem driver only)

•CD-ROM drive

•Windows® 98 SE / Windows® Me / Windows® XP / Windows® 2000

2.2 Step 1: Install the Driver & Utility

Make sure you run the setup utility first before plugging in the PCI Card into your PC. If your PCI Card is plugged into your PC first, the network controller will be prompted. Click Cancel.

Exit all Windows programs. Insert the Installation CD into your CD-ROM. The CD will run automatically. If the Installation CD auto run fails, please run the “Setup.exe” file in the CD.

For Windows 98SE/ME/2000/XP

1. When the Welcome screen appears, click “Next” to continue.

Click Here

Page 5 of 24

Page 4 Page 6
Image 5
Page 4 Page 6
Contents WL630PCI Wireless B/G PCI Card Part15, Class B FCC CertificationFeatures Introduction to WL630PCI Wireless B/G PCI CardPackage Contents Act Indicator Green LED LED IndicatorsPower Indicator Green LED Install the Driver & Utility InstallationSystem Requirements Click HereBelow screen will be shown. Click Next to continue Click Here For Windows Install the DeviceFor Windows 98SE/ME For Windows XP Uninstallation Verify InstallationWindows 98SE/ME Go to Start Æ Settings Æ Control Panel Æ NetworkPage Windows 2000/XP IP Address Configuration Utility Main Tab Built-in Windows Zero Configuration Utility WZCYou check the Configure using Windows Zero Configuration Any WPA ConnectNone Personal Certificate TLSTo supply a Personal Certificate Medium-Power 25% Medium-Low Power 12%Medium-High Power 50% High Power 100%Edit Profile Manager TabNew Information Tab Example of connection to an Access Point Click OK to exit the WEP Configuration
Top Page Image Contents