Aztech Systems WL630PCI user manual Example of connection to an Access Point

Page 23

User Manual

6 Example of connection to an Access Point

1.At the Main tab, highlight one of the devices from the list area that you wish to connect and then press the Connect button to access it.

2. The Profile Configuration window will be displayed so that you can create a profile.

3.The SSID name will appear on the Profile Name. You can change the Profile Name if you wish to.

4.Select Personal for Super Profile and select Open for the Authentication Mode.

5.Select None for the Security if the network does not require special security settings and access rights in order to connect to it. Please proceed to Step 11 on Page 20.

6.Select WEP for the Security if the network requires special security settings and access rights in order to connect to it. Then, click on Configure… to set the WEP Configuration.

Page 23 of 24

Image 23
Contents WL630PCI Wireless B/G PCI Card Part15, Class B FCC CertificationFeatures Introduction to WL630PCI Wireless B/G PCI CardPackage Contents Act Indicator Green LED LED IndicatorsPower Indicator Green LED Click Here InstallationInstall the Driver & Utility System RequirementsBelow screen will be shown. Click Next to continue Click Here For Windows Install the DeviceFor Windows 98SE/ME For Windows XP Uninstallation Verify InstallationWindows 98SE/ME Go to Start Æ Settings Æ Control Panel Æ NetworkPage Windows 2000/XP IP Address Configuration Utility Main Tab Built-in Windows Zero Configuration Utility WZCYou check the Configure using Windows Zero Configuration Any WPA ConnectNone Personal Certificate TLSTo supply a Personal Certificate High Power 100% Medium-Low Power 12%Medium-Power 25% Medium-High Power 50%Edit Profile Manager TabNew Information Tab Example of connection to an Access Point Click OK to exit the WEP Configuration