Aztech Systems WL630PCI user manual Install the Device, For Windows 98SE/ME

Page 8

User Manual

2.3 Step 2: Install the Device

Note: Before you install the device to your computer, make sure you have installed the driver and utility as described in the previous section.

Shut down the PC and remove the power cord from the PC. Locate your PCI slot and then insert the Wireless B/G PCI Card into the slot

For Windows 98SE/ME

4.Before installing the device, make sure you have your original Windows 98 CD-ROM on hand (not required for Windows ME). When the prompt for “Windows 98 Second Edition CD-ROM window appears, insert the CD-ROM as requested. Click “OK” to continue the installation.

5.The installation will continue and the system may prompt for a “Version Conflict”. Click “Yes” to keep the existing file. This completes the installation of the device.

For Windows 2000

4.When the “Digital Signature Not Found” screen appears, click “Yes” to continue the installation.

5. This completes the installation of the device.

Page 8 of 24

Image 8
Contents WL630PCI Wireless B/G PCI Card FCC Certification Part15, Class BFeatures Introduction to WL630PCI Wireless B/G PCI CardPackage Contents Act Indicator Green LED LED IndicatorsPower Indicator Green LED Installation Install the Driver & UtilitySystem Requirements Click HereBelow screen will be shown. Click Next to continue Click Here For Windows Install the DeviceFor Windows 98SE/ME For Windows XP Verify Installation UninstallationGo to Start Æ Settings Æ Control Panel Æ Network Windows 98SE/MEPage Windows 2000/XP IP Address Configuration Utility Main Tab Built-in Windows Zero Configuration Utility WZCYou check the Configure using Windows Zero Configuration Any WPA ConnectNone TLS Personal CertificateTo supply a Personal Certificate Medium-Low Power 12% Medium-Power 25%Medium-High Power 50% High Power 100%Edit Profile Manager TabNew Information Tab Example of connection to an Access Point Click OK to exit the WEP Configuration