Aztech Systems WL630PCI user manual Verify Installation, Uninstallation

Page 10

User Manual

2.4 Verify Installation

To verify if the device exists in your computer and works, go to Start Æ Settings Æ Control Panel Æ System Æ Hardware Æ Device Manager. Expand the Network Adapters category. If the WL630PCI Wireless B/G PCI Card is listed here, it means that your device is properly installed and enabled.

2.5 Uninstallation

1.To uninstall the driver and utility, go to the Control Panel of your system.

2.Open the Add/Remove Programs.

3.Select the WL630PCI Wireless B/G Utility in the Add/Remove Programs and then click on the Remove.

4.Follow the on screen instructions to uninstall the driver and utility. After the uninstallation, shut down and plug out the wireless PCI card.

Page 10 of 24

Image 10
Contents WL630PCI Wireless B/G PCI Card FCC Certification Part15, Class BPackage Contents Introduction to WL630PCI Wireless B/G PCI CardFeatures Power Indicator Green LED LED IndicatorsAct Indicator Green LED System Requirements InstallationInstall the Driver & Utility Click HereBelow screen will be shown. Click Next to continue Click Here For Windows 98SE/ME Install the DeviceFor Windows For Windows XP Verify Installation UninstallationGo to Start Æ Settings Æ Control Panel Æ Network Windows 98SE/MEPage Windows 2000/XP IP Address Configuration Utility You check the Configure using Windows Zero Configuration Built-in Windows Zero Configuration Utility WZCMain Tab None ConnectAny WPA TLS Personal CertificateTo supply a Personal Certificate Medium-High Power 50% Medium-Low Power 12%Medium-Power 25% High Power 100%New Profile Manager TabEdit Information Tab Example of connection to an Access Point Click OK to exit the WEP Configuration