Sierra Wireless X HSUPA manual Power Consumption @12V DC, Standards/Approvals, Host Interfaces

Page 18

Specifications

Power Consumption: (@12V DC)

•Transmit/Receive (Typical/Max) 300/520 mA

•Idle 170 mA

•Low Power Mode 80 mA

•Input Voltage 9 ‐ 28V DC

Standards/Approvals

•Carrier specific approvals

•CE

•FCC

•PTCRB

•Industry Canada

Host Interfaces

•Ethernet: 10/100 Mbps RJ‐45

•USB Type B

•RS‐232: DB‐9 DCE (300‐230400 baud)

•I/O: 4 Digital, 4 Analog, 2 Relay

•Antenna Connection:

·Cellular ‐ 50 Ohm TNC

·GPS ‐ 50 Ohm SMA

Warning: The antenna should be installed no closer than 20 cm from the human body. It is one of the RSS-102 requirements for devices not requiring SAR.

Dimensions

•162mm x 40mm x 109mm

•612 grams

Application Interfaces

•TCP/IP, UDP/IP, DHCP, HTTP, SNMP, SMTP, SMS, MSCI, NMEA, TAIP, GPS, and more

LED Indicators

•Network

•Signal

•Activity

•Service

•GPS


Rev 4.0 Oct.09						12
Rev 4.0 Oct.09						12

Image 18

Contents User Guide Important Notice Safety and Hazards Limitation Liability Patents Copyright Trademarks Contact Information Revision HistoryContents Activating PinPoint X on your cellular provider Introduction to the PinPoint HsupaAleos ACEwareSimplified Deployment Monitor and ControlConnecting to your cellular provider Modem DoctorSteps of a connection Cellular Dynamic vs. Static IP AddressesCommunication Hsupa HsupaConnection methods UmtsNetworking Virtual serial portIPSec Applications SoftwareEvents Reporting Documentation Tools and Reference DocumentsTechnology SpecificationsFeatures and Benefits BandsLED Indicators Power Consumption @12V DCDimensions Standards/ApprovalsInterface Port Pin-Outs Serial PortPort Power Connector Power Connector not to scaleBefore you start Installing the SIMActivating PinPoint X on your Cellular provider Cellular Account RequiredEjecting the SIM tray Opening the SIM SlotRemove the SIM from the card Tools RequiredFinishing the SIM installation Insert the SIM into the TrayInsert the Tray and SIM Configuring the APN Hardware Installation PinPoint Dust, etcConnecting to Power GPS Antenna Placement for a VehicleConnecting to a Computer or other Device Ignition Sense power connectorSerial Indicator Lights Rssi LED Ranges RSSI/Signal LED Status Ranges of Rssi dBmMounting Light PatternsFront Inputs, Relay Outputs, and Power 5 Status Capturing External EventsAnalog Inputs Digital Inputs Relay OutputsConnecting devices to the I/O Port Rev 4.0 Oct.09 Inputs, Relay Outputs, and Power StatusWiring Color Corospondance Power Modes and Information Monitoring and Setting the I/OGetting Immediate Reports Using RAP Wiring the PinPoint X for Power Effect on Modem StateMonitoring Power-In Voltage PinPoint X Hsupa 20080311