Hardware Installation of the Raven XE
Mounting
An optional accessory for your Raven XE is a mounting kit, which includes a bracket. The bracket is designed to snugly cradle the modem and hold it in place where you need it. You can use a strap around the bracket and modem for extra security. The bracket can be attached to a stationary location using #6 screws with the mounting hole diameter approxi‐ mately 0.150ʺ.
The instructions to bracket installation is following:
1.Mount the bracket using number 6 screws. There are two holes each, to fasten screws, and minimum of one hole each end is required for mounting bracket.
2.Position Raven XE between Alignment ears.
3.Engage top groove in body of Raven XE with two tabs.
4.Push on far side of Raven XE in center so that it touches side of Bracket.
5.Press down and release when upper groove on far side of Raven XE, aligns with tabs.
6.Release to complete installation in to mounting bracket.
To remove, press on the two edges of the modem and the brackets, as pointed by arrows in the diagram provided below. By doing this, the modem will snap out of the mounting bracket.
Figure 4-6: Optional Mounting Bracket
|
|
|
|
|
|
|
Rev 1.0 Oct.09 |
|
|
|
|
| 23 |
|
|
|