Connecting the Raven XE
c.To see what you are typing as you type it, you will need to turn on the echo and verbose mode. Type ATE1V1 and press Enter.
d.If you get a reply of “OK”, then you entered the command successfully. If you get a reply of “0” or “ERROR”, try entering the command again.
AT Command
When using a terminal application, you will need to manually type in each command.
•For most commands, when you are entering them using a terminal connection, you will need to preface the command with AT (exceptions are noted), i.e. ATA which is listed as A.
•Some commands have specific parameters while other commands will take whatever you type.
•Required variable parameters are denoted with italicized text, example, Dn. The n is variable.
•Acceptable parameters and/or specific formats are listed with each command.
•Most commands with parameters can be entered with ? to read the current value (for example, AT&D? will respond with “2” if the default has not been changed).
•Optional parameters are denoted with square brackets [ ].
•AT Commands are not case sensitive. A capital “E” is the same as a lower‐case “e”.
•When you are using a terminal connection, if you enter a command which is recognized by the Raven XE, it will respond with “OK”. If the command is not recognized, the response will be “ERROR”.
•Those commands applicable only to certain model numbers of the Raven XE will be noted.
Caution: Symbols listed with commands, such as *, /, &, or ?, are part of the command and must be included. Commands with symbols other than * may require PassThru mode.
|
|
|
|
|
|
|
Rev 1.0 Oct.09 |
|
|
|
|
| 30 |
|
|
|