Scientific Atlanta DPX213 manual Windows

Page 24

Install USB Drivers, Continued

Windows 2000

Follow these steps to install the WebSTAR cable modem USB drivers for Windows 2000 environments.

1.Insert the USB Cable Modem Driver Installation Disk into the CD-ROM drive of your PC.

2.Wait until the Power and Cable indicators on the cable modem illuminate solid green; then, plug the USB cable into the USB port on your PC.

Result: The Found New Hardware Wizard window opens.

3.In the Found New Hardware Wizard window, click Next.

4.In the Found New Hardware Wizard window, select Search for a suitable driver for my device (recommended), then click Next.

5.In the Found New Hardware Wizard window, select CD-ROM drives, and then click Next.

6.In the Found New Hardware Wizard window, click Next.

Result: The system searches for the driver file for your hardware device.

7.After the system finds the USB driver, the Digital Signature Not Found window opens displaying a confirmation message to continue the installation.

8.Click Yes to continue the installation.

Result: The Found New Hardware Wizard window reopens with a message that the installation is complete.

9.Click Finish to close the Found New Hardware Wizard window.

Result: The USB drivers are installed on your PC and your cable modem is ready for use.

Note: If you cannot access the Internet, contact your cable service provider for further assistance.

Continued on next page

4001231 Rev A

WebSTAR Model DPX213 VoIP DOCSIS Cable Modem User's Guide

23

Image 24

Contents Model DPX213 VoIP Docsis Cable Modem Overview IntroductionThis Guide Important Rules for Safe Operation This SectionCleaning the Equipment PlacementRead and Retain These Instructions Important Rules for Safe Operation Power Cord Protection Power SourcesDamage that Requires Service GroundingSection B Before You Begin Equipment Checklist Check Your EquipmentSection C Front and Back Panel Components WebSTAR Cable Modem Front Panel Front Panel ComponentsWebSTAR Cable Modem Back Panel Back Panel ComponentsFront Panel LED Status Indicator Functions Initial Power Up, Calibration, and RegistrationNormal Operations Special Conditions Section D Internet Service Installation Contacting Your Local Cable Service Provider Before You BeginSelecting a Location for Your Modem System Requirements Minimum System Requirements for PCsMinimum System Requirements for Macintosh System Requirements for an Ethernet ConnectionInstall the Cable Modem Installation DiagramInstalling the Modem Configure TCP/IP Configuring the TCP/IP Protocol for Windows 95/98/98SE//MEWindows 95/98/98SE/ME Results Renewing the IP Address for Windows 95/98/98SE/ME Windows Windows XPMacintosh Install USB Drivers Windows 98/98SE/MEWindows Result The Found New Hardware Wizard window opens Frequently Asked Questions Frequently Asked QuestionsTroubleshooting Common Troubleshooting SuggestionsModem does not register an Ethernet connection Modem does not register a cable connectionCheck and Correct Section E Telephone Service Installation Before You Begin Selecting a Location for Your Modem Telephone Wiring Requirements Telephone RequirementsNumber of Telephone Devices Telephone Device TypesInstall the Cable Modem to Provide Telephone Service Installing the Cable Modem to Provide Telephone ServiceInstallation Diagram Installing the Cable Modem Can I use my existing phone number with the cable modem? How many telephones can I connect?There is no dial tone when I lift the telephone handset Trademarks DisclaimerDocumentation Copyright Notice Software Use NoticeFCC Compliance United States FCC ComplianceFCC Declaration of Conformity Canada EMI RegulationFor Information If You Need Technical Assistance