Scientific Atlanta DPX213 Read and Retain These Instructions, Cleaning the Equipment, Placement

Page 4

IMPORTANT RULES FOR SAFE OPERATION

Note to Installer

Note to CATV System Installer

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC (Section 54, Part I of the Canadian Electrical Code), that provides guidelines for proper grounding and, in particular, specifies that the CATV cable ground shall be connected to the grounding system of

the building, as close to the point of cable entry as practical.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

AVIS

CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel.

WARNING

TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

This symbol is intended to alert you that uninsulated voltage within this product may have sufficient magnitude to cause electric shock. Therefore, it is dangerous to make any kind of contact with any inside part of this product.

This symbol is intended to alert you of the presence of important operating and maintenance (servicing) instructions in the literature accompanying this product.

Read and Retain These Instructions

Read all of the instructions before you operate this equipment. Give particular attention to all safety precautions. Retain the instructions for future reference.

Comply with all warning and caution statements in the instructions. Observe all warning and caution symbols that are affixed to this equipment.

Comply with all instructions that accompany this equipment.

Cleaning the Equipment

Before cleaning this equipment, unplug it from the electrical outlet. Use a damp cloth to clean this equipment. Do not use a liquid cleaner or an aerosol cleaner. Do not use a magnetic/static cleaning device (dust remover) to clean this equipment.

Placement

Place this equipment in a location that is close enough to an electrical outlet to accommodate the length of the power cord. Place this equipment on a stable surface. The surface must support the size and weight of this equipment. Place this equipment either horizontally or vertically.

WARNING: Avoid personal injury and damage to this equipment. An unstable surface may cause this equipment to fall.

Continued on next page

4001231 Rev A

WebSTAR Model DPX213 VoIP DOCSIS Cable Modem User's Guide

3

Image 4
Contents Model DPX213 VoIP Docsis Cable Modem Introduction OverviewThis Guide Important Rules for Safe Operation This SectionPlacement Cleaning the EquipmentRead and Retain These Instructions Important Rules for Safe Operation Power Cord Protection Power SourcesDamage that Requires Service GroundingSection B Before You Begin Equipment Checklist Check Your EquipmentSection C Front and Back Panel Components WebSTAR Cable Modem Front Panel Front Panel ComponentsWebSTAR Cable Modem Back Panel Back Panel ComponentsInitial Power Up, Calibration, and Registration Front Panel LED Status Indicator FunctionsNormal Operations Special Conditions Section D Internet Service Installation Before You Begin Contacting Your Local Cable Service ProviderSelecting a Location for Your Modem System Requirements Minimum System Requirements for PCsMinimum System Requirements for Macintosh System Requirements for an Ethernet ConnectionInstall the Cable Modem Installation DiagramInstalling the Modem Configuring the TCP/IP Protocol for Windows 95/98/98SE//ME Configure TCP/IPWindows 95/98/98SE/ME Results Renewing the IP Address for Windows 95/98/98SE/MEWindows Windows XPMacintosh Install USB Drivers Windows 98/98SE/MEWindows Result The Found New Hardware Wizard window opens Frequently Asked Questions Frequently Asked QuestionsTroubleshooting Common Troubleshooting SuggestionsModem does not register an Ethernet connection Modem does not register a cable connectionCheck and Correct Section E Telephone Service Installation Before You Begin Selecting a Location for Your Modem Telephone Wiring Requirements Telephone RequirementsNumber of Telephone Devices Telephone Device TypesInstall the Cable Modem to Provide Telephone Service Installing the Cable Modem to Provide Telephone ServiceInstallation Diagram Installing the Cable Modem Can I use my existing phone number with the cable modem? How many telephones can I connect?There is no dial tone when I lift the telephone handset Trademarks DisclaimerDocumentation Copyright Notice Software Use NoticeFCC Compliance United States FCC ComplianceFCC Declaration of Conformity Canada EMI RegulationFor Information If You Need Technical Assistance