Scientific Atlanta DPX213 manual Before You Begin

Page 30

Before You Begin

Contacting Your Local Cable Service Provider

You need to set up a telephone account with your local cable service provider in order to use your cable modem for telephone service. When you contact your cable service provider, verify the following conditions:

Does the cable service to your home supports two-way, DOCSIS-compatible cable modem access? If your cable service provider does not provide two-way service, this modem will not be able to communicate with your cable service provider’s Internet access and telephone services.

Can you transfer your existing telephone numbers from another telephony service provider to your current cable telephony service provider? In some areas, you may be able to transfer your existing telephone numbers, or your cable telephony service provider will assign a new telephone number for each current or additional active telephone line. Discuss these options with your cable telephony service provider.

You must also give your cable service provider the following information:

The serial number of the modem

The Media Access Control (MAC) address of the modem

These numbers appear on a bar code label located on the cable modem. The serial number consists of a series of alphanumeric characters preceded by S/N. The MAC address consists of a series of alphanumeric characters preceded by MAC. The following illustration shows a sample bar code label.

Serial Number

MAC Address

T10327

Continued on next page

4001231 Rev A

WebSTAR Model DPX213 VoIP DOCSIS Cable Modem User's Guide

29

Image 30
Contents Model DPX213 VoIP Docsis Cable Modem Overview IntroductionThis Guide Important Rules for Safe Operation This SectionCleaning the Equipment PlacementRead and Retain These Instructions Important Rules for Safe Operation Damage that Requires Service Power Cord ProtectionPower Sources GroundingSection B Before You Begin Equipment Checklist Check Your EquipmentSection C Front and Back Panel Components WebSTAR Cable Modem Front Panel Front Panel ComponentsWebSTAR Cable Modem Back Panel Back Panel ComponentsFront Panel LED Status Indicator Functions Initial Power Up, Calibration, and RegistrationNormal Operations Special Conditions Section D Internet Service Installation Contacting Your Local Cable Service Provider Before You BeginSelecting a Location for Your Modem Minimum System Requirements for Macintosh System RequirementsMinimum System Requirements for PCs System Requirements for an Ethernet ConnectionInstall the Cable Modem Installation DiagramInstalling the Modem Configure TCP/IP Configuring the TCP/IP Protocol for Windows 95/98/98SE//MEWindows 95/98/98SE/ME Results Renewing the IP Address for Windows 95/98/98SE/MEWindows Windows XPMacintosh Install USB Drivers Windows 98/98SE/MEWindows Result The Found New Hardware Wizard window opens Frequently Asked Questions Frequently Asked QuestionsModem does not register an Ethernet connection TroubleshootingCommon Troubleshooting Suggestions Modem does not register a cable connectionCheck and Correct Section E Telephone Service Installation Before You Begin Selecting a Location for Your Modem Number of Telephone Devices Telephone Wiring RequirementsTelephone Requirements Telephone Device TypesInstall the Cable Modem to Provide Telephone Service Installing the Cable Modem to Provide Telephone ServiceInstallation Diagram Installing the Cable Modem Can I use my existing phone number with the cable modem? How many telephones can I connect?There is no dial tone when I lift the telephone handset Documentation Copyright Notice TrademarksDisclaimer Software Use NoticeFCC Declaration of Conformity FCC ComplianceUnited States FCC Compliance Canada EMI RegulationFor Information If You Need Technical Assistance