Phonecell Operation, Important Tones and Alerts

Phonecell Operation – Continued

Important Tones and Alerts

No-Service Tone – When cellular service is not available, the receiver emits a No-Service (fast-beeping)tone instead of the normal (steady) dial tone.

ROH (Receiver Off-Hook) Tone – If the telephone equipment remains off-hook (off its cradle) with no dialing activity for 45 seconds, the receiver emits an ROH tone for 60 seconds.

Incoming Call Alert – If you’re dialing a number and an incoming call occurs, the receiver will emit an audible ring. To answer the incoming call:

·Press the “HOOKFLASH” button once. This will connect the incoming call.

·OR hang-up immediately. This will cause the phone to start ringing.

How to Adjust the Volume Level

If the volume level on your phone is too high or too low, you can adjust the levels using the keypad on your telephone. Note: your telephone must be in Tone-

Dial (DTMF) mode to adjust the levels.

To Increase Audio Level - Increase the audio level in steps by pressing:

Φ# * 8 (also known as # * Up)

Continue to press # * 8 until the desired level is reached.

To Decrease Audio Level - Decrease the audio level in steps by pressing:

Φ# * 3 (also known as # * Down)

Continue to press # * 3 until the desired level is reached.

NOTE: The default setting lets you adjust the audio up to three (3) steps in either direction (Up or Down).

Fax/Data Transmission

Automatic Level Setting (ALS)

When your Phonecell SX3 detects a fax or modem call, it automatically adjusts the Transmit and Receive audio levels for optimum data transmission. After the fax/data transmission is completed, the Phonecell resets the audio levels to their previous settings (patent pending).

Fax/Modem Compatibility

Your Phonecell is compatible with all Group 3 facsimile machines and computer modems. Depending upon the type of modem used and the cellular network’s capability, data transmission rates of 2400 baud and higher are normally possible.

PHONECELL SX3i AMPS

USER MANUAL 12/08/99