Step 2. Plug In Your Telephone
Your Phonecell SX3 lets you connect up to 5 pieces of standard telephone equip-
ment into a cellular network. Follow the steps below for quick installation.
Connect Your Telephone:
1)Locate the modular
2)Connect the other end of the cord to the
of your Phonecell SX3i – see Fig. 5.
Place a Call – Adjust Your FWT:
1)Pick up the phone receiver and listen for dial tone.
2)If you hear dial tone, make a call.
3)While you’re talking with the other party, listen for static and echo. If you hear either, move the antenna until you find the spot where voice conver- sation is strong, and static
and echo are minimized.
NOTE: If you are unsuccessful in dialing out, verify the following:
·The antenna location needs to be adjusted – see Step 1, page
·The NAM/Phone Number needs to be set up – see Step 3, page
·Your cellular phone number has not been activated – contact your cel- lular service provider.
Adding More Phones?
Plug in an
Additional Telephone Equipment:
If you plan to use a device other than a telephone with your Phonecell SX3 (such as a modem), make sure that device will work with a normal wired telephone line.
Fax Machines – Connect a fax machine the same way it needs to be set up for use on a regular wired telephone line.
PBX/KSU Systems – PABX installation should only be performed by experienced telephone technicians.
Fig. 5 |
|
To | |
|
|
Phone Cord 
To Phone(s)
To
Modem
Line
SplitterRJ-11
Port
Phone
Cords
Fig. 6 Optional RJ-11 Line Splitter lets you connect additional phone equipment to your Phonecell SX3i.
IMPORTANT!
Make sure the wiring from the telephone equipment to your
!Phonecell SX3 is properly protected from all transient voltages, including lightning.
PHONECELL SX3i AMPS | 8 | USER MANUAL 12/08/99 |