Telular SX3i Technician Programming Commands, How to Set the Access Overload Class Accolc

Technician Programming Commands – Continued

How to Set the Access Overload Class (ACCOLC)

Use the following key sequence to set the ACCOLC: Press: Φ # * 2 * < ACCOLC > #

The < > brackets represent the 2-digitACCOLC. You must enter a 2-digit value between 00 and 15, otherwise the FWT will not update or store this value; the existing stored parameter will remain. (For example, to program the FWT for ACCOLC 8, enter: # * 2 * 08 #.)

How to Set the Access Method (EX) Option

Use the following key sequence to set the EX option:

Press: Φ # * 3 * <EX option> #

The < > brackets represent the 1-digitEX option:

enter: Φ1 if the FWT must always send the full MIN (Mobile Identification Number) when accessing the system

enter: Φ0 if not.

You must enter either 0 or 1, otherwise the FWT will not update or store this value; the existing stored parameter will remain. The factory default setting is 1.

How to Set the Roam Option

Use the following key sequence to set the Roam option:

Press: Φ # * 6 * <Roam option> #

The < > brackets represent the 1-digitRoam option: enter: Φ0 to enable roaming

enter: Φ1 to disable roaming.

You must enter either 0 or 1, otherwise the FWT will not update or store this value; the existing stored parameter will remain. The factory default setting is 0.

How to Set the Dial Tone After Remote On-Hook Option

Use the following key sequence to set the Dial Tone After Remote On-Hook option:

Press: Φ # * 8 * <Dial Tone option> #

The < > brackets represent the 1-digitdial tone option: enter: Φ0 for no dial tone after a remote on-hook enter: Φ1 to enable dial tone after remote on-hook.

You must enter either 0 or 1, otherwise the FWT will not update or store this value; the existing stored parameter will remain. The factory default setting is 1.

PHONECELL SX3i AMPS 25 USER MANUAL 12/08/99