Phonecell Operation – Continued
Three-Way Conference Calls - For three-way conference calls, the Out-of-Band Signaling option must be enabled. Pressing the HOOKFLASH function transmits the SEND command. Please see the Data After SEND option below.
Voice Mail – Out-of-Band Signaling may need to be disabled to interact with remote voice mail systems to prevent double-pulsing. See the Data After SEND option below.
Authentication (A-Key) – Depending upon your cellular provider, you may be required to enter an Authentication Code (A-Key)before you make or receive any calls. A-Key is a cellular system solution to prevent cloning, counterfeiting and cel- lular fraud. To program the A-Key function, see the Technician Programming
Section – page 27.
Data After SEND (In-Call Signaling) Option
Depending upon your cellular provider, the Data After SEND option may need to be Enabled or Disabled to use special cellular features such as call waiting, three- way conference calls, voice mail, etc. Please consult your service provider for the required Data After Send/In-Call DTMF Signaling configuration.
The Data After SEND option is disabled (Out-of-Band signaling) at the factory. To change the Data After SEND setting, follow the steps below.
How To Set the In-Call DTMF Signaling Option - Pick up the handset and listen for dial tone. Then, enter the User-Programming mode by pressing:
Φ# * 0 * 1 2 3 4 5 6 7 8 #
The dial tone should change to a steady “Programming” tone and the LED indicator on the front of your Phonecell should blink alternately RED and GREEN to indicate that you’re now in the Programming mode.
Next, press: Φ# * 10 * <in-call DTMF option> #
The < > brackets represents the in-call DTMF signaling option. You must enter a value between 0 and 3:
enter Φ 0 for In-Band Signaling; enter Φ 1 for Out-of-Band Signaling;
enter Φ 2 for both In-Band and Out-of-Band signaling; enter Φ 3 for neither.
If you enter the option incorrectly, you’ll hear three short beeps followed by the programming tone. That’s your cue to re-try the steps above. If correct, you’ll hear the programming tone again. Hang up. Your Phonecell is ready for use.
Zero Dial Delay for Frequently Called Numbers
A new patented feature enables the Phonecell to recognize your frequently called phone numbers and send them immediately–without the 3-second Auto SEND Delay. The Phonecell stores a list of up to 50 numbers in its memory. This list con- tains any number that you’ve called at least twice successfully. NOTE: cycling (turning ON/OFF) the power will erase the current list. A new list will be started when power is re-applied. To enable or disable this feature, see page 26.
