2 - Connecting the SAGEM F@st™ 1000
2.3Installation procedure
This section summarizes the procedure when installing the SAGEM F@st™ 1100 for the first time.
!Check the compatibility of the mains supply with the SAGEM F@st™ 1100.
!Check with your Operator to ensure that the ADSL line is available.
!Check with your Access Provider to ensure that your subscription is valid.
!Install the drivers of your SAGEM F@st™ 1000.
!Connect the SAGEM F@st™ 1000:
•to the mains supply,
•to the remote network via an ADSL compatible telephone line,
•to your computer via USB interface.
!Check that the connections have been correctly made, as indicated by the four LEDs on the SAGEM F@st™ 1000. The required LED states will depend on whether the USB or Ethernet mode is used:
PWR | LINE | USB | DATA |
|
|
|
|
Green, on steady | Green, on steady | Green, on steady | Green, on steady |
|
|
|
|
This table shows the state of the LEDs before connecting the USB cable (see chapter 3 for details).
!Finish the installation of your modem.
User Guide - N56815740110
No reproduction or communication without the written consent of SAGEM SA | Page |