Sagem N56815740110 manual Installing for Windows XP, Installing the modem

3 - Installing the SAGEM F@stTM 1000 modem

3.2Installing for Windows XP

For Windows XP professional, the installation of the SAGEM F@stTM 1000 modem is carried out according to the following process :

!Installing the modem drivers,

-ADSLBOOT driver: This driver is required when the modem starts-up (boot loader),

-VVBusUSB driver: It manages data exchanges on the USB bus,

-VVBATM driver: It manages the ATM link layer.

!Configuring the ATM parameters.

Remark: All those steps are realized automatically by the installation software.

3.2.1Installing the modem

!Switch off the modem if it is powered by unplugging the power supply cable either on the modem side (connector marked PWR), or on the mains side.

!Switch on the PC and wait for the complete start-up of Windows XP.

!Insert the installation CD-ROM; the home page appears after a few seconds.

If this screen does not appear automatically proceed as follows:

From the Start menu select Run then enter <Drive letter for the CD-ROM>:\English\Setup.exe.

!Select Modem setup on this page.

The install program copies the files to the PC's hard drive, then displays the following message:

!Click OK and connect the modem to the PC with the USB cable, and to the telephone line (ADSL) with the line cable.

!Connect the power supply cable to the modem (connector marked PWR), then connect the mains adapter to power up the SAGEM F@stTM 1000.

Windows detect the new hardware and installs successively ADSLBOOT, VVBusUSB et VVB ATM drivers. Messages displayed at the botton right of Windows desktop inform you about the status of the installation process

Remark : If a message window about the digital signature of the drivers (Windows logo) appears during installation, click on "Continue" to go on with the installation of the modem.

User Guide - N56815740110

No reproduction or communication without the written consent of SAGEM SA Page 3-3