Chauvet Laser Pointer user manual Safety Notes

Page 5

Safety Notes

CAUTION! The use of optical instruments with this product will increase eye hazard.

Please read the following notes carefully because they include important safety information about the installation, usage, and maintenance of this product.

Keep this User Manual for future consultation. If you sell this product to another user, be sure that they also receive this document.

Always make sure that the voltage of the outlet to which you are connecting this product is within the range stated on the decal or rear panel of the product.

This product is for indoor use only! To prevent risk of fire or shock, do not expose this product to rain or moisture.

Make sure there are no flammable materials close to the unit while operating.

Always install this product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.

Always disconnect this product from the power source before cleaning it or replacing fuse.

Make sure to replace the fuse with another of the same type and rating.

If mounting it overhead, always secure this product to a fastening device using a safety chain.

The maximum ambient temperature (Ta) is 104° F (40° C). Do not operate this product at higher temperatures.

In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance center.

Never connect this product to a dimmer pack.

Make sure the power cord is not crimped or damaged.

Never disconnect the power cord by pulling or tugging on the cord.

Never carry a product from the power cord or any moving part. Always use the hanging/mounting bracket or the handles.

Always avoid direct eye exposure to the light source when this product is on.

Lasers can be hazardous and have unique safety considerations. Permanent eye injury and blindness is possible if lasers are used incorrectly. Pay close attention to each safety REMARK and WARNING statement in this user manual. Read all instructions carefully BEFORE operating this device.

Avoid direct eye contact with laser light. Never intentionally expose your eyes or others to direct laser light.

This laser product can potentially cause instant eye injury or blindness if laser light directly strikes the eyes.

It is illegal and dangerous to shine this laser into audience areas, where the audience or other personnel could get direct laser beams or bright reflections into their eyes.

It is a US Federal offense to shine any laser at aircraft.

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

There are no user serviceable parts inside the unit. Do not open the housing or attempt any repairs yourself. In the unlikely event your unit may require service, please contact the dealer nearest to you.

Scorpion™ GBC User Manual

5

August 2011

Image 5
Contents Laser Light Avoid Direct EYE Exposure Product at a Glance Contact InformationDocument Information Table of Contents Unpacking Instructions What Is IncludedClaims Text ConventionsSafety Notes Stop and Read ALL the Laser Safety Notes below Non Interlocked Housing WarningLaser Safety Notes Laser Safety Labels Reproduction Laser Compliance Statement Laser Emission DataLaser Exposure Laser light Avoid direct eye contactBack Panel IntroductionProduct Overview Product Dimensions Power Linking SetupAC Power Mounting Fuse ReplacementOrientation RiggingProper Usage DMX Operation OperationControl Panel Standalone Operation DMX Channel SummaryAutomatic Sound-ActiveMenu Functions Master/Slave OperationPattern selection only when CH1 is between Manual Mode use channels 2~10 in this modeDMX Channel Values 000~017Channel 2 Values Pattern Selection Technical Information General TroubleshootingSymptom Solutions Applies to World Wide Returns ProcedureContact Us DMX Primer Setting up a DMX Serial Data LinkOutpu Data CablingInpu Product Linking Setting the Starting AddressTechnical Specifications