Cleaning solutions
This section describes various cleaning solutions that have been tested by
Motion Computing. Please review the manufacturer's guidelines for proper use of the product. Reference:
Product Type | Manufacturer | Comments |
|
|
|
Alcohol Prep Pads | Dynarex | For general purpose use only. Not considered a |
|
| disinfectant for health care environments. |
|
|
|
Metrex | Can be difficult to clean off. Can leave a film on | |
|
| the product. |
|
|
|
Germicidal Wipes | PDI | Requires gloves for use and can be difficult to |
(Super |
| clean off. Effective on acrylic displays but can be |
|
| difficult to clean off the ViewAnywhere display. |
|
|
|
MOC Reviver | MOC | Can be difficult to clean off. Can leave a film on |
|
| the product. |
|
|
|
Triad | Can leave a yellow film on the product. | |
|
|
|
PDI | Requires gloves for use and can be difficult to | |
|
| clean off. |
|
|
|
Screen Cleaner | Office Depot | For general purpose use only. Not considered a |
|
| disinfectant for health care environments. |
|
|
|
Veridien | Highly recommended. | |
|
|
|
Virex | Virex | Can be difficult to clean off. Can leave a film on |
|
| the product. |
|
|
|
Cleaning the fingerprint reader
Under normal circumstances, you should clean the fingerprint reader once a month, or whenever necessary.
To clean the fingerprint reader
1.Shut down the Tablet PC, unplug it, and remove the battery.
2.Lightly spray a cotton swab with household window cleaner.
3.Gently rub the sensor surface with the cotton swab, slowly rotating the swab so a new, clean surface of the swab is constantly exposed to the sensor surface. Do not allow cleaner to drip or run down into the electronics around the sensor.
Do not use bleach, solvents, or abrasives. Do not spray or pour any liquid directly on the sensor.
4.After cleaning, gently rub the surfaces again with a clean, dry cotton swab. Use a clean swab each time you clean the sensor.
62 | Chapter 4 Care and Maintenance |