Compatible Systems 3500R manual Getting Started

Page 14

8	Chapter 2 - Getting Started

ϖNote: Please use only the supplied cables when connecting your V.35 line communication device to the RISC Router 3500R’s interfaces. The cables provided with other equipment will generally not have the same internal connections.

ϖNote: For international applications, V.11 cables are available from Compatible Systems or your reseller.

Image 14

Contents Risc Router 3500R Installation Guide Page Getting Started Hardware InstallationIntroduction Basic Configuration Guide CompatiView Software InstallationLink Configuration Smds Addressing Appendix a Shipping Defaults Systems Appendix E Terms and ConditionsAbout the Risc Router 3500R Risc Router 3500R Installation OverviewIntroduction IntroductionGetting Started Hardware InstallationCompatiView Software Installation Appendices Introduction Command Line PreparationBasic Configuration Guide Page Few Notes Warranty and ServiceGetting Started Please Read The ManualsSupplied with the Risc Router 3500R Needed For InstallationWhat You Will Need To Get Started Ethernet Connection Requirements10BaseT Twisted-Pair Ethernet Telco Line Connection RequirementsGetting Started Thick Ethernet InterfaceGetting Started Hardware Installation Mounting the RouterConnecting the Router to the Ethernet Powering Up the Router Connecting a Line Device to the Risc Router 3500RConnecting an Out-of-Band Management Console Connecting Devices to the V.35 InterfacesHardware Installation System Requirements Installation and OperationCompatiView for Windows Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementTemporarily Reconfiguring a Host for Command Line Management Setting Up Telnet OperationCommand Line Management Page Basic Configuration Guide Required for IP Ethernet Interface ConfigurationIP Protocol Suggested for IPDECnet Protocol IPX ProtocolAppleTalk Protocol Suggested for DECnet WAN Interface ConfigurationPhysical Communications Settings Suggested for Dedicated/Leased Line Operation Link ConfigurationRequired for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationSuggested for Dial-On-Demand Operation IPX Protocol DECnet Protocol Basic Configuration Guide Suggested for DECnet Frame Relay Dlci MappingsRequired for IP Numbered Interface Required for IP Unnumbered InterfaceBasic Configuration Guide Suggested for IP TB Use configure and set the Mode keyword in the DECnet WAN Smds Configuration Smds AddressingSaving a Configuration File to Flash ROM Ethernet Interface Appendix a Shipping DefaultsDefault Password WAN InterfacesAppleTalk Defaults Link & Physical DefaultsAppendix B Connector and Cable Pin Outs Pin Outs for DB-26 to V.35 Male CablePin Outs for DIN-8 to RS-232 Console Cable DTE/ Female Other Indicators on All LED Bars Power On, No TrafficTraffic Indicators Ethernet LED Bar Risc Router 3500R LED PatternsRisc Router 3500R Switch Settings Appendix C LED Patterns and Test Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions