Compatible Systems manual Risc Router 3500R Switch Settings

Page 44

38 Appendix C - LED Patterns and Test Switch Settings

RISC Router 3500R Switch Settings

0

Normal Operation

 

 

1

Unused*

 

 

2

Unused*

 

 

3

Run Boot ROM Downloader

 

 

4

Unused*

 

 

5

Erase Flash ROM (OS and Configuration)

 

 

6

Erase Flash ROM (Configuration Only)

 

 

7

Unused*

 

 

8

Unused*

 

 

9

Allow letmein password for 5 minutes after powerup

 

 

ΜCaution: Settings marked with an asterisk may erase your Flash ROM. Please do not use these settings without first contacting Compatible Systems Technical Support.

Image 44
Contents Risc Router 3500R Installation Guide Page Getting Started Hardware InstallationIntroduction Basic Configuration Guide CompatiView Software InstallationLink Configuration Smds Addressing Appendix a Shipping Defaults Systems Appendix E Terms and ConditionsRisc Router 3500R Installation Overview IntroductionAbout the Risc Router 3500R IntroductionGetting Started Hardware InstallationCompatiView Software Installation Appendices Introduction Command Line PreparationBasic Configuration Guide Page Warranty and Service Getting StartedFew Notes Please Read The ManualsNeeded For Installation What You Will Need To Get StartedSupplied with the Risc Router 3500R Ethernet Connection RequirementsTelco Line Connection Requirements Getting Started Thick Ethernet10BaseT Twisted-Pair Ethernet InterfaceGetting Started Hardware Installation Mounting the RouterConnecting the Router to the Ethernet Connecting a Line Device to the Risc Router 3500R Connecting an Out-of-Band Management ConsolePowering Up the Router Connecting Devices to the V.35 InterfacesHardware Installation System Requirements Installation and OperationCompatiView for Windows Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementTemporarily Reconfiguring a Host for Command Line Management Setting Up Telnet OperationCommand Line Management Page Basic Configuration Guide Ethernet Interface Configuration IP ProtocolRequired for IP Suggested for IPDECnet Protocol IPX ProtocolAppleTalk Protocol Suggested for DECnet WAN Interface ConfigurationPhysical Communications Settings Link Configuration Required for Dedicated/Leased Line OperationSuggested for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationSuggested for Dial-On-Demand Operation IPX Protocol DECnet Protocol Basic Configuration Guide Suggested for DECnet Frame Relay Dlci MappingsRequired for IP Numbered Interface Required for IP Unnumbered InterfaceBasic Configuration Guide Suggested for IP TB Use configure and set the Mode keyword in the DECnet WAN Smds Configuration Smds AddressingSaving a Configuration File to Flash ROM Appendix a Shipping Defaults Default PasswordEthernet Interface WAN InterfacesAppleTalk Defaults Link & Physical Defaults Appendix B Connector and Cable Pin Outs Pin Outs for DB-26 to V.35 Male CablePin Outs for DIN-8 to RS-232 Console Cable DTE/ Female Power On, No Traffic Traffic Indicators Ethernet LED BarOther Indicators on All LED Bars Risc Router 3500R LED PatternsRisc Router 3500R Switch Settings Appendix C LED Patterns and Test Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions