Compatible Systems 3500R manual Introduction, Getting Started, Hardware Installation

Page 3

Chapter 1 - Introduction

1

ABOUT THE RISC ROUTER 3500R

1

A NOTE ABOUT ON-DEMANDINTERNETWORKING

1

RISC ROUTER 3500R INSTALLATION OVERVIEW

1

Chapter 2 - Getting Started

5

 

 

A FEW NOTES

5

Please Read The Manuals

5

Warranty and Service

5

Getting Help With the RISC Router 3500R

5

WHAT YOU WILL NEED TO GET STARTED

6

Supplied with the RISC Router 3500R

6

Needed For Installation

6

Ethernet Connection Requirements

6

Thick Ethernet

7

10BaseT Twisted-Pair Ethernet

7

Telco Line Connection Requirements

7

V.35 Interface

7

Chapter 3 - Hardware Installation

9

 

 

Mounting the Router

9

19" Rack Front Mount

10

19" Rack Center Mount

10

Wall Mount

10

Connecting the Router to the Ethernet

10

Connecting to Thick Ethernet

10

Connecting to Twisted-Pair Ethernet

10

Connecting a Line Device to the RISC Router 3500R

11

Connecting Devices to the V.35 Interfaces

11

Connecting an Out-of-Band Management Console

11

Powering Up the Router

11

i

Image 3
Contents Risc Router 3500R Installation Guide Page Hardware Installation IntroductionGetting Started CompatiView Software Installation Basic Configuration GuideLink Configuration Smds Addressing Systems Appendix E Terms and Conditions Appendix a Shipping DefaultsIntroduction Risc Router 3500R Installation OverviewIntroduction About the Risc Router 3500RHardware Installation CompatiView Software InstallationGetting Started Introduction Command Line Preparation Basic Configuration GuideAppendices Page Please Read The Manuals Warranty and ServiceGetting Started Few NotesEthernet Connection Requirements Needed For InstallationWhat You Will Need To Get Started Supplied with the Risc Router 3500RInterface Telco Line Connection RequirementsGetting Started Thick Ethernet 10BaseT Twisted-Pair EthernetGetting Started Mounting the Router Hardware InstallationConnecting the Router to the Ethernet Connecting Devices to the V.35 Interfaces Connecting a Line Device to the Risc Router 3500RConnecting an Out-of-Band Management Console Powering Up the RouterHardware Installation Installation and Operation CompatiView for WindowsSystem Requirements Transport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementSetting Up Telnet Operation Temporarily Reconfiguring a Host for Command Line ManagementCommand Line Management Page Basic Configuration Guide Suggested for IP Ethernet Interface ConfigurationIP Protocol Required for IPIPX Protocol AppleTalk ProtocolDECnet Protocol WAN Interface Configuration Physical Communications SettingsSuggested for DECnet Required for Dial-On-Demand Operation Link ConfigurationRequired for Dedicated/Leased Line Operation Suggested for Dedicated/Leased Line OperationSuggested for Dial-On-Demand Operation IPX Protocol DECnet Protocol Frame Relay Dlci Mappings Basic Configuration Guide Suggested for DECnetRequired for IP Unnumbered Interface Required for IP Numbered InterfaceBasic Configuration Guide Suggested for IP TB Use configure and set the Mode keyword in the DECnet WAN Smds Addressing Smds ConfigurationSaving a Configuration File to Flash ROM WAN Interfaces Appendix a Shipping DefaultsDefault Password Ethernet InterfaceLink & Physical Defaults AppleTalk DefaultsPin Outs for DB-26 to V.35 Male Cable Appendix B Connector and Cable Pin OutsPin Outs for DIN-8 to RS-232 Console Cable DTE/ Female Risc Router 3500R LED Patterns Power On, No TrafficTraffic Indicators Ethernet LED Bar Other Indicators on All LED BarsAppendix C LED Patterns and Test Switch Settings Risc Router 3500R Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms and Conditions Appendix E Terms ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions