Compatible Systems 3500R manual Command Line Management

Page 23

Chapter 5 - Command Line Management	17

B.Use the save command to save the changes to the device’s Flash ROM.

•You may also use CompatiView from a reconfigured IP host (if using the IP transport protocol), or anywhere on your network (if using the IPX transport protocol). Instructions for these two methods are given in Chapter 4 - CompatiView Software Installation.

With CompatiView, basic IP parameters can be set using the TCP/IP Routing: Ethernet 0 Dialog Box. Use the Save to/ Device option under the File menu to save the changes.

After you have set these IP parameters and saved the changes, you can use Telnet to access the router from any node on your IP network. Invoke the Telnet client on your local host with the IP address of the router you wish to manage.

Image 23

Contents Risc Router 3500R Installation Guide Page Getting Started Hardware InstallationIntroduction CompatiView Software Installation Basic Configuration GuideLink Configuration Smds Addressing Systems Appendix E Terms and Conditions Appendix a Shipping DefaultsIntroduction Risc Router 3500R Installation OverviewIntroduction About the Risc Router 3500RGetting Started Hardware InstallationCompatiView Software Installation Appendices Introduction Command Line PreparationBasic Configuration Guide Page Please Read The Manuals Warranty and ServiceGetting Started Few NotesEthernet Connection Requirements Needed For InstallationWhat You Will Need To Get Started Supplied with the Risc Router 3500RInterface Telco Line Connection RequirementsGetting Started Thick Ethernet 10BaseT Twisted-Pair EthernetGetting Started Mounting the Router Hardware InstallationConnecting the Router to the Ethernet Connecting Devices to the V.35 Interfaces Connecting a Line Device to the Risc Router 3500RConnecting an Out-of-Band Management Console Powering Up the RouterHardware Installation System Requirements Installation and OperationCompatiView for Windows Transport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementSetting Up Telnet Operation Temporarily Reconfiguring a Host for Command Line ManagementCommand Line Management Page Basic Configuration Guide Suggested for IP Ethernet Interface ConfigurationIP Protocol Required for IPDECnet Protocol IPX ProtocolAppleTalk Protocol Suggested for DECnet WAN Interface ConfigurationPhysical Communications Settings Required for Dial-On-Demand Operation Link ConfigurationRequired for Dedicated/Leased Line Operation Suggested for Dedicated/Leased Line OperationSuggested for Dial-On-Demand Operation IPX Protocol DECnet Protocol Frame Relay Dlci Mappings Basic Configuration Guide Suggested for DECnetRequired for IP Unnumbered Interface Required for IP Numbered InterfaceBasic Configuration Guide Suggested for IP TB Use configure and set the Mode keyword in the DECnet WAN Smds Addressing Smds ConfigurationSaving a Configuration File to Flash ROM WAN Interfaces Appendix a Shipping DefaultsDefault Password Ethernet InterfaceLink & Physical Defaults AppleTalk DefaultsPin Outs for DB-26 to V.35 Male Cable Appendix B Connector and Cable Pin OutsPin Outs for DIN-8 to RS-232 Console Cable DTE/ Female Risc Router 3500R LED Patterns Power On, No TrafficTraffic Indicators Ethernet LED Bar Other Indicators on All LED BarsAppendix C LED Patterns and Test Switch Settings Risc Router 3500R Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms and Conditions Appendix E Terms ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions