Acnodes RMC 7189 user manual Jumper Settings, Explanation of Jumpers, Cmos Clear, To clear Cmos

RMC 7189

1U Rackmount System

5-9 Jumper Settings

Explanation of Jumpers

To modify the operation of the mother- board, jumpers can be used to choose between optional settings. Jump- ers create shorts between two pins to change the func- tion of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. See the motherboard layout pages for jumper locations.

Note: On a two-pin jumper, "Closed" means the jumper is on both pins and "Open" means the jumper is either on only one pin or completely removed.

CMOS Clear

JBT1 is used to clear CMOS (which will also clear any passwords). Instead of pins, this jumper consists of contact pads to prevent accidentally clearing the contents of CMOS.

To clear CMOS,

1.First power down the system and unplug the power cord(s).

2.With the power disconnected, short the CMOS pads with a metal object such as a small screwdriver.

3.Remove the screwdriver (or shorting device).

4.Reconnect the power cord(s) and power on the system.

Note: Do not use the PW_ON connector to clear CMOS.

VGA Enable/Disable

JPG1 allows you to enable or disable the VGA port.

The default position is on pins 1 and 2 to enable VGA.

See the table on the right for jumper settings.

	© Copyright 2009 Acnodes, Inc.
661 Brea Canyon Rd., Suite 3	All rights reserved. Product description and product specifications
Walnut, CA 91789	are subject to change without notice. For latest product information,
tel: 909.598.7388, fax: 909.598.0218	please visit Acnodes’ web site at www.acnodes.com.