8e6 Technologies MSA-004-005 quick start Link the Workstation to the ProxyBlocker, Boot Up Process

Page 32

Link the Workstation to the ProxyBlocker

The procedures outlined in this sub-section require the use of the CAT-5E crossover cable.

A. Plug one end of the CAT-5E crossover cable into the ProxyBlocker’s LAN 2 port.

NOTE: When facing the rear of the chassis, the LAN 2 port is the port on the right.

Portion of chassis rear

B.Plug the other end of the CAT-5E crossover cable into the setup workstation’s net- work card.

NOTE: If a CAT-5E coupler was packaged with your unit, this coupler can be used if the crossover cable is not long enough for your setup. Plug one end of the CAT-5E crossover cable into the ProxyBlocker, and the other end into the coupler. Plug a standard CAT-5E cable into the other end of the coupler, and the free end of the standard CAT-5E cable into the setup workstation.

C. Plug the ProxyBlocker into a power source with an appropriate rating.

WARNING: It is strongly suggested you use an uninterruptible power supply.

D.Power on the ProxyBlocker by lowering the bezel and pressing the large button at the right of the front panel (see diagram below):

Diagram of chassis front panel, power button at far right

The Boot Up Process

The boot-up process may take 5 - 10 minutes. When the drive light remains off for 30 seconds, the system is booted up. (See the LED Indicators and Buttons section for a description of Front LED Indicators and Buttons for Hardware Status Monitoring.)

28	8e6 ProxyBlocker Quick Start Guide

Image 32

Contents Guide 8e6 ProxyBlocker Quick Start Guide Contents 8e 6 Proxy Blocker Quick Start Guide 8e6 ProxyBlocker Introduction About this Document Conventions Used in this Document8e6 Taiwan Procedures8e6 Corporate Headquarters USA Unpack the Unit from the Carton Select a Site for the Server Rack Setup Precautions Rack Mount the ServerOptional Install the Chassis Rails Rack Mount Instructions8e6 ProxyBlocker Quick Start Guide Optional Install the Traditional UP Racks 8e6 ProxyBlocker Quick Start Guide Optional Install the Open Racks 8e6 ProxyBlocker Quick Start Guide 8e6 ProxyBlocker Quick Start Guide Install the Chassis into the Rack Check the Power Supply Power Supply PrecautionsGeneral Safety Information Server Operation and Maintenance PrecautionsAC Power Cord and Cable Precautions Electrical Safety PrecautionsMotherboard Battery Precautions Administrator Console Setup Requirements Setup ProceduresWizard Setup Requirements Wizard Setup Procedures Monitor and Keyboard SetupSerial Console Setup Link the Workstation to the ProxyBlockerHyperTerminal Setup Procedures 8e6 ProxyBlocker Quick Start Guide 8e6 ProxyBlocker Quick Start Guide Login screen System Configuration ScreenSystem Configuration Administration menu System Status Screen Log Off, Disconnect the PeripheralsWorkstation Configurations Console Setup ProceduresPreliminary Setup Boot Up Process Network Setup Access the ProxyBlocker Administrator ConsoleLog in to ProxyBlocker Administrator Console Network Network Operation Mode Network LAN Settings Network NTP Servers Network Regional Setting Physically Connect the ProxyBlocker to the Network Test the ProxyBlocker Console Connection Activate and Register the ProxyBlocker Set Library UpdatesTest Filtering Perform a Complete Library Update Monitor the Library Update Process Conclusion MSA Units LED Indicator Key Button KeyLED Indicator Color Condition Description Safety Compliance Declaration of the Manufacturer or ImporterElectromagnetic Compatibility EMC Electromagnetic Compatibility Class a NoticeEC Declaration of Conformity Index Wizard setup 19 8e6 ProxyBlocker Quick Start Guide