Oracle Audio Technologies SG-XPCIE2FC-ATCA-Z manual To Connect the Optical Cable

FIGURE 2-2Inserting the HBA Into the AMC Connector

4.Carefully plug the HBA into the AMC connector (FIGURE 2-2). Ensure that the HBA is seated correctly in the connector.

Caution – Do not use excessive force when installing the HBA into the slot. You might damage the AMC connector on the Netra board, causing permanent damage to the HBA or board. If the HBA does not seat properly when you apply even pressure, remove the HBA and carefully reinstall it.

5.If the module handle was pulled out when you inserted the HBA, push the handle all the way in.

6.If the server is powered on, the HS LED next to the module handle blinks two or three times.

When the HS LED goes dark, the HBA is installed.

▼To Connect the Optical Cable

Note – The HBA does not allow normal data transmission on an optical link unless it is connected to another similar or compatible Fibre Channel (FC) product (that is, multimode to multimode).

Use multimode fiber-optic cable that is intended for short-wave lasers. The cable must adhere to the specifications in TABLE 2-1.

10 Sun StorageTek ATCA 4Gb FC Dual Port HBA Installation Guide • April 2010