Packard Bell ST manual TV Antenna Optional, Disconnecting DC jack

Page 25

2424242424	24

2. Remove the two screws securing the DC jack.

Fig. 39 Disconnecting DC jack.

3. Take out the DC jack.

TV Antenna (Optional)

To remove the optional TV antenna cable, first remove the Ethernet/USB board (see Ethernet/USB Board on page 20), and then perform the following steps:

1. Carefully disconnect the TV antenna cable (see Fig. 7 on page 7).

Packard Bell EasyNote ST Disassembly Manual

Image 25

Contents EasyNote ST Table of Contents Reassembly DisassemblyAbout this Guide For More Information Technician NotesHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Hard Disk Drives BatteryMemory Disconnecting and removing hard disk driveRemoving memory module Wireless LAN AdapterTV Tuner Optional Location of antenna cable connector and screwOptical Disk Drive Intel Turbo Memory OptionalLocation tray bezel lock underside KeyboardRemoving keyboard Keyboard CoverLocation keyboard cover screws Top CoverLocation of cover screws in keyboard compartment Disconnecting button board flat cable LCD AssemblyLocation LCD hinge screws SpeakersLocation of speaker cable header on the main board Main BoardLocation of cooler cable and screws Disconnecting optional Bluetooth cable Location of Ethernet/USB flat cable CPU and Heat SinkLocation of screw securing CPU Cmos BatteryUSB/Audio Board Bluetooth OptionalEthernet/USB Board Remove the subwoofer cable from the Ethernet/USB board Releasing Ethernet/USB board flat cable SubwooferLocation subwoofer screws DC JackTV Antenna Optional Disconnecting DC jackTouchpad Location of TV antenna connectorLCD Bezel Button BoardInverter Board Location of grounding screw LCD PanelWebcam/Microphone Location of LCD cable connectorEasyNote ST Disassembly Manual