Packard Bell ST manual Button Board, LCD Bezel, Inverter Board

Page 27

2626262626

26

Button Board

To remove the button board, first remove the top cover (see Top Cover on page 11), and then perform the following steps:

1. Remove the three screws securing the button board.

Fig. 42 Location of button board screws.

2. Remove the button board.

LCD Bezel

To remove the LCD bezel, first remove the LCD assembly (see LCD Assembly on page 13), and then perform the following steps:

1.Remove the eight screw covers on the LCD bezel (four at the top and four at the bottom).

2.Remove the screws that became accessible after removing the covers.

3.Carefully pry open the LCD bezel; it has been clicked into place.

Inverter Board

To remove the inverter board, first remove the LCD bezel (see LCD Bezel on page 26), and then do the following:

1. Disconnect the cable on both ends of the inverter board.

Fig. 43 Location of inverter board.

2.Remove the screw securing the inverter board (see Fig. 43 on page 26).

3.Extract the inverter board.

Packard Bell EasyNote ST Disassembly Manual

Image 27
Contents EasyNote ST Table of Contents For More Information Technician Notes DisassemblyReassembly About this GuidePower Supply Unit Hazardous VoltageAvoid Electrostatic Discharge Hard Disk Drives BatteryMemory Disconnecting and removing hard disk driveRemoving memory module Wireless LAN AdapterTV Tuner Optional Location of antenna cable connector and screwOptical Disk Drive Intel Turbo Memory OptionalLocation tray bezel lock underside KeyboardRemoving keyboard Keyboard CoverLocation keyboard cover screws Top CoverLocation of cover screws in keyboard compartment Disconnecting button board flat cable LCD AssemblyLocation LCD hinge screws SpeakersLocation of speaker cable header on the main board Main BoardLocation of cooler cable and screws Disconnecting optional Bluetooth cable Location of Ethernet/USB flat cable CPU and Heat SinkLocation of screw securing CPU Cmos BatteryBluetooth Optional USB/Audio BoardEthernet/USB Board Remove the subwoofer cable from the Ethernet/USB board Releasing Ethernet/USB board flat cable SubwooferLocation subwoofer screws DC JackTV Antenna Optional Disconnecting DC jackTouchpad Location of TV antenna connectorButton Board LCD BezelInverter Board Location of grounding screw LCD PanelWebcam/Microphone Location of LCD cable connectorEasyNote ST Disassembly Manual