FieldServer FS-8700-20 instruction manual Creating the Network Configuration File for the Master

Page 10

FS-8700-20 Profibus DP Driver Manual

Page 10 of 22

4.6.Creating the Network Configuration File for the Master

The output of this procedure is a bridge.bss file that has to be downloaded to the FieldServer.

1)Start the SST Profibus Network Configuration Tool and drag the 5136-PFB-ISA MASTER [Rev 1.3] Master device into the right-hand window pane.

2)Set the Station to be the same as defined under System_Station_Address in the config.csv file. Click OK to close the Master window.

3)Right-click on the PROFIBUS_DP icon and choose Properties to configure the network.

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldServer.com

Image 10

Contents FS-8700-20 Profibus DP Table of Contents Profibus DP Description FS-8700-20 Profibus DP Driver ManualSoftware Provided by the Supplier of 3rd Party Equipment HardwareFieldServer Technologies Description Hardware Connections Hardware TroubleshootingSST Profibus card LEDs Profibus Master Configuration Using COM Profibus for Profibus Master ConfigurationGeneral Configuring the FieldServer as a Profibus DP MasterData Arrays/ Descriptors Client Side Connection Descriptions Client Side Node DescriptorsClient Side Map Descriptors RDBC, WrbcCreating the Network Configuration File for the Master Important Note FS-8700-20 Profibus DP Driver Manual Configuring the FieldServer as a Profibus DP Slave Only Server Side Connection Descriptions Server Side Node DescriptorsServer Side Map Descriptors DPBuffer Description Appendix A.2. DataType, Address & LengthDataType Description DPBuffer Function DP slave the data will be sent or fetched from FS-8700-20 Profibus DP Driver Manual Appendix C.2. FieldServer as a Profibus Master Master Mode not enabled This page Intentionally Left Blank