FieldServer FS-8700-20 Hardware Connections, Hardware Troubleshooting, SST Profibus card LEDs

Page 5

FS-8700-20 Profibus DP Driver Manual

Page 5 of 22

3.Hardware Connections

The FieldServer is equipped with a SST 5136-PFB-ISA interface card, which has a standard Profibus DB-9 interface available for connection to the Profibus network. If the FieldServer is located at an end of the network, termination will be required. For more information on Profibus cables and connections, please refer to the documentation provided on the SST CD.

WARNING: Improper cabling can cause physical layer problems that are hard to diagnose. The FieldServer is connected to the Profibus DP as shown in the connection drawing below:

Configure the Profibus DP according to manufacturer’s instructions

 

SST 5136-PFB ISA card

 

 

Comms LED

 

Sys LED

 

 

1

FS-X40

Phoenix Connector

2

 

3

 

 

 

 

4

 

 

5

 

 

8

 

DB 9 Connector 3

 

 

1

NOTES

1)Connect only via the Phoenix or DB9 connector to the Profibus network.

2)Terminate DB9 by connecting pin 1-2 and 4-5 on the Phoenix connector

A

GND

B

OR

A

GND

B

(408)-262-2299

PROFIBUS DP

CONNECTION DIAGRAM

BASE NAME:

 

DATE: 03/09/04

FILE NAME:

 

BY: MC

 

 

 

3.1.Hardware Troubleshooting

During initialization, the Profibus DP driver checks for the 5136-PFB-ISA hardware and checks for any conflicts with other hardware. If any errors occur during initialization, an entry in the error log will be produced.

3.2.SST Profibus card LEDs

There are two LEDs on the SST Profibus Card. When operating normally the COM LED should remain solid green. Any communications errors will cause it to flash red for at least one second. The SYS LED shows the status of both the master and slave. If using either the slave or master, the SYS LED will show green if all is ok, amber if all is ok but the bus is running in program mode, and red if there is a problem. If running both master and slave, the LED will sequence through the master status, the slave status and then off.

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldServer.com

Image 5
Contents FS-8700-20 Profibus DP Table of Contents FS-8700-20 Profibus DP Driver Manual Profibus DP DescriptionFieldServer Technologies Description Provided by the Supplier of 3rd Party Equipment HardwareSoftware SST Profibus card LEDs Hardware TroubleshootingHardware Connections Using COM Profibus for Profibus Master Configuration Profibus Master ConfigurationData Arrays/ Descriptors Configuring the FieldServer as a Profibus DP MasterGeneral Client Side Node Descriptors Client Side Connection DescriptionsRDBC, Wrbc Client Side Map DescriptorsCreating the Network Configuration File for the Master Important Note FS-8700-20 Profibus DP Driver Manual Configuring the FieldServer as a Profibus DP Slave Only Server Side Node Descriptors Server Side Connection DescriptionsServer Side Map Descriptors DataType Description Appendix A.2. DataType, Address & LengthDPBuffer Description DPBuffer Function DP slave the data will be sent or fetched from FS-8700-20 Profibus DP Driver Manual Appendix C.2. FieldServer as a Profibus Master Master Mode not enabled This page Intentionally Left Blank