FieldServer FS-8700-20 instruction manual Master Mode not enabled

Page 21

FS-8700-20 Profibus DP Driver Manual

Page 21 of 22

Appendix C.3. Error and Informational Messages on Ruinet E and F screens

Master Mode not enabled

This message means that the FieldServer is not set up to be a Profibus DP Master. This indicates that the FieldServer did not find a Master scanner file, (bridge.bss). This message is normal if you configured the FieldServer to be a DP Slave. See the sections on configuring the FieldServer as either a DP Master or Slave.

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldServer.com

Image 21

Contents FS-8700-20 Profibus DP Table of Contents FS-8700-20 Profibus DP Driver Manual Profibus DP DescriptionProvided by the Supplier of 3rd Party Equipment Hardware SoftwareFieldServer Technologies Description Hardware Troubleshooting Hardware ConnectionsSST Profibus card LEDs Using COM Profibus for Profibus Master Configuration Profibus Master ConfigurationConfiguring the FieldServer as a Profibus DP Master GeneralData Arrays/ Descriptors Client Side Node Descriptors Client Side Connection DescriptionsRDBC, Wrbc Client Side Map DescriptorsCreating the Network Configuration File for the Master Important Note FS-8700-20 Profibus DP Driver Manual Configuring the FieldServer as a Profibus DP Slave Only Server Side Node Descriptors Server Side Connection DescriptionsServer Side Map Descriptors Appendix A.2. DataType, Address & Length DPBuffer DescriptionDataType Description DPBuffer Function DP slave the data will be sent or fetched from FS-8700-20 Profibus DP Driver Manual Appendix C.2. FieldServer as a Profibus Master Master Mode not enabled This page Intentionally Left Blank