| Page 3 of 37 |
3.Hardware Connections
The FieldServer is connected to the PLC as shown in connection drawing.
Configure the PLC according to manufacturer’s instructions to work with other FINS supported device.
1.03Hardware Connection Tips / Hints
If communication doesn’t start check the following.
1.Are the FieldServer and PLC on the same network?
2.Are all intended Nodes configured to communicate on FINS?
3.Are all FINS Nodes configured to use the same Port Number?
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com Tel: (408)