ISonic K8NF4G-SATA2 manual Installation of Memory Modules Dimm, Notch break

Page 13

2.3Installation of Memory Modules (DIMM)

This motherboard is equipped with two 184-pin DDR (Double Data Rate) DIMM slots.

Please make sure to disconnect power supply before adding or removing DIMMs or the system components.

Step 1. Unlock a DIMM slot by pressing the retaining clips outward.

Step 2. Align a DIMM on the slot such that the notch on the DIMM matches the break on the slot.

notch break

The DIMM only fits in one correct orientation. It will cause permanent damage to the motherboard and the DIMM if you force the DIMM into the slot at incorrect orientation.

Step 3. Firmly insert the DIMM into the slot until the retaining clips at both ends fully snap back in place and the DIMM is properly seated.

1 3

Image 13

Contents K8NF4G-SATA2 Disclaimer Copyright NoticeContents Appendix AMD’s Cool ‘n’ QuietTM Technology Software SupportIntroduction Package ContentsSpecifications Support CD Bios FeatureHardware MonitorPage RoHS Motherboard LayoutTable for Audio Output Connection HD 8CH I/OPre-installation Precautions InstallationInstallation of CPU Fan and Heatsink CPU InstallationNotch break Installation of Memory Modules DimmEasy Multi Monitor Feature Installing an expansion cardExpansion Slots PCI Express Slots, PCI Slots and Hdmr SlotOnboard Headers and Connectors Jumpers SetupSetting IDE1 Infrared Module Header System Panel Header Western Digital Sataii Hard Disk Setup GuidePage Use RAID Installation Guide to set RAID configuration Set Up BiosMake a Sata / Sataii Driver Diskette Untied Overclocking Technology Bios Menu Bar Main Screen Navigation KeysTo jump to the Exit Screen or exit the current screen System Time HourMinuteSecondOverclock Mode CPU ConfigurationAdvanced Screen CPU Frequency MHzPcie Frequency MHz Boot Failure GuardCPU Spread Spectrum Pcie Spread SpectrumProcessor Voltage Processor MultiplierMemory Clock Flexibility OptionChipset Configuration Acpi Configuration Sataii Operation Mode IDE ConfigurationIDE Device Configuration OnBoard IDE ControllerPIO Mode LBA/Large ModeDMA Mode Block Multi-Sector TransferPCI Latency Timer PCIPnP ConfigurationA.R.T 32Bit Data TransferSuper IO Configuration Floppy ConfigurationOnBoard Floppy Controller Serial Port AddressECP Mode DMA Channel Parallel Port ModeParallel Port Address EPP VersionHardware Health Event Monitoring Screen USB ConfigurationUSB Controller USB 2.0 SupportBoot Settings Configuration Boot ScreenBoot From Network Boot Up Num-LockChange Supervisor Password Main Advanced Monitor BootSecurity Screen Exit Screen Load Optimal DefaultsSave Changes and Exit Discard Changes and ExitSupport CD Information Install Operating SystemRunning The Support CD Drivers MenuAppendix