ISonic K8NF4G-SATA2 manual IDE Configuration, OnBoard IDE Controller, OnBoard Sataii Controller

3.3.4 IDE Configuration

	BIOS SETUP UTILITY
Advanced
IDE Configuration		DISABLED: disables the
		integrated IDE
		Controller.
OnBoard IDE Controller	[Both]	PRIMARY: enables only
OnBoard SATAII Controller	[Enabled]	the Primary IDE
SATAII Operation Mode	[non-RAID]	Controller.
		SECONDARY: enables
Primary IDE Master	[Hard Disk]	only the Secondary IDE
Primary IDE Slave	[Not Detected]	Controller.
Secondary IDE Master	[ATAPI CDROM]	BOTH: enables both IDE
Secondary IDE Slave	[Not Detected]	Controllers.
SATAII 1	[Not Detected]		Select Screen
SATAII 2	[Not Detected]
			Select Item
		+-	Change Option
		F1	General Help
		F9	Load Defaults
		F10	Save and Exit
		ESC	Exit
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

OnBoard IDE Controller

You may enable either the primary IDE channel or the secondary IDE channel. Or you may enable both the primary and the secondary IDE channels by selecting [Both]. Set to [Disabled] will disable the both. Configuration options: [Disabled], [Primary], [Secondary], [Both].

OnBoard SATAII Controller

Use this item to enable or disable the “OnBoard SATAII Controller” feature.

SATAII Operation Mode

Use this item to adjust SATAII Operation Mode. The default value of this option is [non-RAID]. If you want to operate RAID function on SATA / SATAII HDDs, please select [RAID].

IDE Device Configuration

You may set the IDE configuration for the device that you specify. We will use the “Primary IDE Master” as the example in the following instruction, which can be applied to the configurations of “Primary IDE Slave”, “Sec- ondary IDE Master”, and “Secondary IDE Slave” as well.

3 0