ISonic K8NF4G-SATA2 manual Copyright Notice, Disclaimer

Page 2

Copyright Notice:

No part of this manual may be reproduced, transcribed, transmitted, or translated in any language, in any form or by any means, except duplication of documentation by the purchaser for backup purpose, without written consent of ASRock Inc.

Products and corporate names appearing in this manual may or may not be regis- tered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners’ benefit, without intent to infringe.

Disclaimer:

Specifications and information contained in this manual are furnished for informa- tional use only and subject to change without notice, and should not be constructed as a commitment by ASRock. ASRock assumes no responsibility for any errors or omissions that may appear in this manual.

With respect to the contents of this manual, ASRock does not provide warranty of any kind, either expressed or implied, including but not limited to the implied warran- ties or conditions of merchantability or fitness for a particular purpose.

In no event shall ASRock, its directors, officers, employees, or agents be liable for any indirect, special, incidental, or consequential damages (including damages for loss of profits, loss of business, loss of data, interruption of business and the like), even if ASRock has been advised of the possibility of such damages arising from any defect or error in the manual or product.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

ASRock Website: http://www.asrock.com

2

Image 2
Contents K8NF4G-SATA2 Copyright Notice DisclaimerContents Software Support Appendix AMD’s Cool ‘n’ QuietTM TechnologyPackage Contents IntroductionSpecifications Hardware Bios FeatureSupport CD MonitorPage Motherboard Layout RoHSHD 8CH I/O Table for Audio Output ConnectionInstallation Pre-installation PrecautionsCPU Installation Installation of CPU Fan and HeatsinkInstallation of Memory Modules Dimm Notch breakExpansion Slots Installing an expansion cardEasy Multi Monitor Feature PCI Express Slots, PCI Slots and Hdmr SlotSetting Jumpers SetupOnboard Headers and Connectors IDE1 Infrared Module Header System Panel Header Sataii Hard Disk Setup Guide Western DigitalPage Make a Sata / Sataii Driver Diskette Set Up BiosUse RAID Installation Guide to set RAID configuration Untied Overclocking Technology Bios Menu Bar To jump to the Exit Screen or exit the current screen Navigation KeysMain Screen System Time HourMinuteSecondAdvanced Screen CPU ConfigurationOverclock Mode CPU Frequency MHzCPU Spread Spectrum Boot Failure GuardPcie Frequency MHz Pcie Spread SpectrumMemory Clock Processor MultiplierProcessor Voltage Flexibility OptionChipset Configuration Acpi Configuration IDE Device Configuration IDE ConfigurationSataii Operation Mode OnBoard IDE ControllerDMA Mode LBA/Large ModePIO Mode Block Multi-Sector TransferA.R.T PCIPnP ConfigurationPCI Latency Timer 32Bit Data TransferOnBoard Floppy Controller Floppy ConfigurationSuper IO Configuration Serial Port AddressParallel Port Address Parallel Port ModeECP Mode DMA Channel EPP VersionUSB Controller USB ConfigurationHardware Health Event Monitoring Screen USB 2.0 SupportBoot From Network Boot ScreenBoot Settings Configuration Boot Up Num-LockSecurity Screen Main Advanced Monitor BootChange Supervisor Password Save Changes and Exit Load Optimal DefaultsExit Screen Discard Changes and ExitRunning The Support CD Install Operating SystemSupport CD Information Drivers MenuAppendix