ISonic K8NF4G-SATA2 manual Security Screen, Main Advanced Monitor Boot, Change Supervisor Password

Page 37

3.6Security Screen

In this section, you may set or change the supervisor/user password for the system. For the user password, you may also clear it.

BIOS SETUP UTILITY

Main

Advanced

H/W Monitor

Boot

Security

Exit

Security Settings

Supervisor Password	: Not Installed
User Password	: Not Installed

Change Supervisor Password

Change User Password

Install or Change the password.

	Select Screen
	Select Item
Enter	Change
F1	General Help
F9	Load Defaults
F10	Save and Exit
ESC	Exit

3 7

Image 37

Contents K8NF4G-SATA2 Disclaimer Copyright NoticeContents Appendix AMD’s Cool ‘n’ QuietTM Technology Software SupportIntroduction Package ContentsSpecifications Support CD Bios FeatureHardware MonitorPage RoHS Motherboard LayoutTable for Audio Output Connection HD 8CH I/OPre-installation Precautions InstallationInstallation of CPU Fan and Heatsink CPU InstallationNotch break Installation of Memory Modules DimmEasy Multi Monitor Feature Installing an expansion cardExpansion Slots PCI Express Slots, PCI Slots and Hdmr SlotOnboard Headers and Connectors Jumpers SetupSetting IDE1 Infrared Module Header System Panel Header Western Digital Sataii Hard Disk Setup GuidePage Use RAID Installation Guide to set RAID configuration Set Up BiosMake a Sata / Sataii Driver Diskette Untied Overclocking Technology Bios Menu Bar Main Screen Navigation KeysTo jump to the Exit Screen or exit the current screen System Time HourMinuteSecondOverclock Mode CPU ConfigurationAdvanced Screen CPU Frequency MHzPcie Frequency MHz Boot Failure GuardCPU Spread Spectrum Pcie Spread SpectrumProcessor Voltage Processor MultiplierMemory Clock Flexibility OptionChipset Configuration Acpi Configuration Sataii Operation Mode IDE ConfigurationIDE Device Configuration OnBoard IDE ControllerPIO Mode LBA/Large ModeDMA Mode Block Multi-Sector TransferPCI Latency Timer PCIPnP ConfigurationA.R.T 32Bit Data TransferSuper IO Configuration Floppy ConfigurationOnBoard Floppy Controller Serial Port AddressECP Mode DMA Channel Parallel Port ModeParallel Port Address EPP VersionHardware Health Event Monitoring Screen USB ConfigurationUSB Controller USB 2.0 SupportBoot Settings Configuration Boot ScreenBoot From Network Boot Up Num-LockChange Supervisor Password Main Advanced Monitor BootSecurity Screen Exit Screen Load Optimal DefaultsSave Changes and Exit Discard Changes and ExitSupport CD Information Install Operating SystemRunning The Support CD Drivers MenuAppendix