ISonic K8NF4G-SATA2 manual PCIPnP Configuration, A.R.T, 32Bit Data Transfer, PCI Latency Timer

Page 32

S.M.A.R.T.

Use this item to enable or disable the S.M.A.R.T. (Self-Monitoring, Analysis, and Reporting Technology) feature. Configuration options: [Disabled], [Auto], [Enabled].

32Bit Data Transfer

Use this item to enable 32-bit access to maximize the IDE hard disk data transfer rate.

3.3.5 PCIPnP Configuration

BIOS SETUP UTILITY

Advanced

Advanced PCI / PnP Settings

WARNING: Setting wrong values in below sections may cause system to malfunction.

PCI	Latency Timer	[64]
PCI	IDE BusMaster	[Enabled]

Value in units of PCI clocks for PCI device latency timer register.

	Select Screen
	Select Item
+-	Change Option
F1	General Help
F9	Load Defaults
F10	Save and Exit
ESC	Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Setting wrong values in this section may cause the system to malfunction.

PCI Latency Timer

The default value is 32. It is recommended to keep the default value unless the installed PCI expansion cards’ specifications require other settings.

PCI IDE BusMaster

Use this item to enable or disable the PCI IDE BusMaster feature.

3 2

Image 32

Contents K8NF4G-SATA2 Copyright Notice DisclaimerContents Software Support Appendix AMD’s Cool ‘n’ QuietTM TechnologyPackage Contents IntroductionSpecifications Bios Feature Support CDHardware MonitorPage Motherboard Layout RoHSHD 8CH I/O Table for Audio Output ConnectionInstallation Pre-installation PrecautionsCPU Installation Installation of CPU Fan and HeatsinkInstallation of Memory Modules Dimm Notch breakInstalling an expansion card Easy Multi Monitor FeatureExpansion Slots PCI Express Slots, PCI Slots and Hdmr SlotSetting Jumpers SetupOnboard Headers and Connectors IDE1 Infrared Module Header System Panel Header Sataii Hard Disk Setup Guide Western DigitalPage Make a Sata / Sataii Driver Diskette Set Up BiosUse RAID Installation Guide to set RAID configuration Untied Overclocking Technology Bios Menu Bar Navigation Keys Main ScreenTo jump to the Exit Screen or exit the current screen System Time HourMinuteSecondCPU Configuration Overclock ModeAdvanced Screen CPU Frequency MHzBoot Failure Guard Pcie Frequency MHzCPU Spread Spectrum Pcie Spread SpectrumProcessor Multiplier Processor VoltageMemory Clock Flexibility OptionChipset Configuration Acpi Configuration IDE Configuration Sataii Operation ModeIDE Device Configuration OnBoard IDE ControllerLBA/Large Mode PIO ModeDMA Mode Block Multi-Sector TransferPCIPnP Configuration PCI Latency TimerA.R.T 32Bit Data TransferFloppy Configuration Super IO ConfigurationOnBoard Floppy Controller Serial Port AddressParallel Port Mode ECP Mode DMA ChannelParallel Port Address EPP VersionUSB Configuration Hardware Health Event Monitoring ScreenUSB Controller USB 2.0 SupportBoot Screen Boot Settings ConfigurationBoot From Network Boot Up Num-LockSecurity Screen Main Advanced Monitor BootChange Supervisor Password Load Optimal Defaults Exit ScreenSave Changes and Exit Discard Changes and ExitInstall Operating System Support CD InformationRunning The Support CD Drivers MenuAppendix