ISonic K8NF4G-SATA2 manual

Page 20

2.9 Serial ATA (SATA) / Serial ATAII (SATAII) Hard Disks Installation

This motherboard adopts nVidia nForce 410 MCP southbridge chipset that supports Serial ATA (SATA) / Serial ATAII (SATAII) hard disks and RAID functions. You may install SATA / SATAII hard disks on this motherboard for internal storage devices. This section will guide you to install the SATA / SATAII hard disks.

STEP 1: Install the SATA / SATAII hard disks into the drive bays of your chassis.

STEP 2: Connect the SATA power cable to the SATA / SATAII hard disk.

STEP 3: Connect one end of the SATA data cable to the motherboard’s SATAII connector.

STEP 4: Connect the other end of the SATA data cable to the SATA / SATAII hard

disk.

2 0

Image 20

Contents K8NF4G-SATA2 Copyright Notice DisclaimerContents Software Support Appendix AMD’s Cool ‘n’ QuietTM TechnologyPackage Contents IntroductionSpecifications Bios Feature Support CDHardware MonitorPage Motherboard Layout RoHSHD 8CH I/O Table for Audio Output ConnectionInstallation Pre-installation PrecautionsCPU Installation Installation of CPU Fan and HeatsinkInstallation of Memory Modules Dimm Notch breakInstalling an expansion card Easy Multi Monitor FeatureExpansion Slots PCI Express Slots, PCI Slots and Hdmr SlotSetting Jumpers SetupOnboard Headers and Connectors IDE1 Infrared Module Header System Panel Header Sataii Hard Disk Setup Guide Western DigitalPage Make a Sata / Sataii Driver Diskette Set Up BiosUse RAID Installation Guide to set RAID configuration Untied Overclocking Technology Bios Menu Bar Navigation Keys Main ScreenTo jump to the Exit Screen or exit the current screen System Time HourMinuteSecondCPU Configuration Overclock ModeAdvanced Screen CPU Frequency MHzBoot Failure Guard Pcie Frequency MHzCPU Spread Spectrum Pcie Spread SpectrumProcessor Multiplier Processor VoltageMemory Clock Flexibility OptionChipset Configuration Acpi Configuration IDE Configuration Sataii Operation ModeIDE Device Configuration OnBoard IDE ControllerLBA/Large Mode PIO ModeDMA Mode Block Multi-Sector TransferPCIPnP Configuration PCI Latency TimerA.R.T 32Bit Data TransferFloppy Configuration Super IO ConfigurationOnBoard Floppy Controller Serial Port AddressParallel Port Mode ECP Mode DMA ChannelParallel Port Address EPP VersionUSB Configuration Hardware Health Event Monitoring ScreenUSB Controller USB 2.0 SupportBoot Screen Boot Settings ConfigurationBoot From Network Boot Up Num-LockSecurity Screen Main Advanced Monitor BootChange Supervisor Password Load Optimal Defaults Exit ScreenSave Changes and Exit Discard Changes and ExitInstall Operating System Support CD InformationRunning The Support CD Drivers MenuAppendix